Can I use wd40 on my furnace motor?
Don’t over-lubricate Some older furnaces have two motor bearings and two blower shaft bearings that require annual oiling. wd40 is actually more of a penetrating oil, not much of a lubricant. It is great in it’s own way but go with the Zoom spout or 3-in-one type machine oil.
How to fix X Trail blower fan noise?
You will note that there are no screws holding the blower fan motor in place, so it is a matter of rotating it and pulling it out. Try and use WD40 on the blower fan and see if that fixes the noise and it would also help us if you can take photos of the blower fan motor when you take it out and tell us if it has a bearing in it or not.
Why is my Nissan Xtrail blower motor not working?
my Nissan xtrail 2005 blower motor is not working I have checked fuses and replaced the thermal fuse in the resister, when I disconnect the lead on the blower switch on and use power tester it shows no power,so what is the likely cause Expert: indy-tech replied 4 years ago.
What to do if your Nissan X Trail heater is making noise?
Dont bother with oiling bushings. You either need to replace thé fan unit or have the bushings replaced with sealed bearings on your existing fan blower motor. You will find info on how to donc this on the Australians x trail forum. Just Google x trail fan noise. I replaced mine at the starter of déc.
Why does my X Trail make a noise?
There does appear to be a little bit of play between the fan and motor, which could account for the fact that the noise doesnt start immediately the fan is switched on, but once it starts it stays until switched off.
You will note that there are no screws holding the blower fan motor in place, so it is a matter of rotating it and pulling it out. Try and use WD40 on the blower fan and see if that fixes the noise and it would also help us if you can take photos of the blower fan motor when you take it out and tell us if it has a bearing in it or not.
There does appear to be a little bit of play between the fan and motor, which could account for the fact that the noise doesnt start immediately the fan is switched on, but once it starts it stays until switched off.
How to remove a blower motor from a car?
Remove glove box assembly. Remove glove box cover, instrument passenger lower panel and instrument reinforcement. Remove ECM with ECM bracket attached. Remove instrument panel mounting screw. Remove blower unit mounting bolt and screws. Disconnect blower motor connector and fan control amp. Connector.
What kind of bearing for T30 blower fan?
The replacement bearing that fits the T30 blower fan is 698ZZ bearing which costs about $5.00 bucks and you will need to buy and use a 8mm washer between the bearing and the retaining clip on each end to make up the slack in the differences between the width between original bushes and the new bearings.