Can I drive without a serpentine belt?
Under no circumstances can you drive a vehicle without a serpentine belt because the serpentine belt serves the important function of delivering antifreeze to important parts of the engine. The serpentine belt drives the water pump, and without it, there is insufficient coolant flow to maintain the engine temperature.
Will a car start without a serpentine belt?
The short answer is yes, your car will start even if the serpentine belt is broken or missing. To get the car going, the battery sends power to your starter motor. However, you do need your serpentine belt if you want the car to run for longer than a few minutes.
What happens if a serpentine belt breaks while driving?
A broken serpentine belt can lead to a sudden loss of power steering in your car, making your steering very difficult to turn. A broken serpentine belt causes the water pump to stop circulating coolant through the engine’s cooling system, causing it to overheat.
How do you replace the serpentine belt on a Toyota?
An adjustment bolt on the alternator provides belt tension on Toyota’s 1.8L engine. This belt is easier to replace than many, but does require that the alternator mounts are loosened up.
Where is the tensioner on a serpentine belt?
Locate the serpentine belt tensioner on the upper right side of the engine. You should see a small square hole in the arm of the tensioner. Insert a 1/2-inch drive ratchet or breaker bar into the hole. Grasp the handle of the ratchet or breaker bar, and pull it to toward the driver’s side of the car, releasing the tension on the belt.
How do you replace a belt on a car?
Grasp the handle of the ratchet or breaker bar, and pull it to toward the driver’s side of the car, releasing the tension on the belt. Slide the belt off the pulleys, and remove it from the engine compartment. Install the new belt over the pulleys, being sure to follow the same path as the old belt.
How do you replace a serpentine car battery?
There should be 1/2″ of deflection at the midpoint of the longest straight run of the belt. 3) Tighten the lower 14mm pivot bolt. 4) Tighten the upper 12mm mounting bolt, below the adjuster. 5) Re-connect the battery. 6) Test. Numerous boisterous screeching clamors or other general motor commotions can be followed back to your serpentine belt.