Can a GMC 305 be swapped for a 350?
It’s basically a direct swap. Whether the tranny will hold up or not is a loaded question and ALL depends on the health of the trans. Years ago i took the 305 out of my 77 and put in a crate 350 (before LS swaps were a thing) and I just kept my trans in it without doing anything.
Can a GMC Truck be replaced with a 350?
Whether the tranny will hold up or not is a loaded question and ALL depends on the health of the trans. Years ago i took the 305 out of my 77 and put in a crate 350 (before LS swaps were a thing) and I just kept my trans in it without doing anything. Well, pretty shortly after I found out I need a trans rebuild because it was tired.
How to remove distributor 88-95 GMC Chevy truck 5.0?
Removing, Rebuilding Installing Distributor 88-95 GMC Chevy truck 5.0 5.7 How to? If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
When did my 95 TBI Chevy stop running?
Timeline and service related incidents— Little over a year ago, it quit a couple times—I mean locked down like the key was switched off. My local indie tech replaced the distributor (O’Reilly’s).
Is the Chevy 305 the same as the 350?
GM might not have made the 305 as performance-oriented as its big brother 350, but they sure made a lot of them. The Chevrolet 305 was the engine of choice for millions of full-sized GM cars and trucks that were too large for a V6 but didn’t require a 350 just to cruise around town.
How to get 350 horsepower out of a 305 Chevy small block?
Bolt a 500 cfm carburetor to the manifold atop the nitrous plate, and install a GM High Energy Ignition (HEI) distributor with 8 mm plug wires. Use a set of high heat-range plugs that can withstand the nitrous, and use a nitrous-compatible ignition control box to retard timing while running under nitrous.