Can a CV axle be removed from a Mazda 6?
This step only applies to the passenger side CV Axle. It is easiest for most people to remove the intermediate shaft and the CV axle while they are still connected to each other. Then, you can put the intermediate shaft in a vise, and hammer out the CV axle.
How do you replace a passenger side axle?
Take the 17mm bolt you remove and thread it into the other side of the spindle. Then take a flat, thin piece of metal and insert it into the slot at the back. Then thread in the bolt more and more so it pushes against the piece of metal you used.
How long does it take to replace an axle on a Mazda 6?
Assembly: Front CV axle assembly (The steps for an AWD Mazda rear axle assembly are similar.) Time to complete: 2 hours (give or take, depending on experience) 1. Order an OEM Replacement Axle Assembly
Can a car axle fail at any point?
This is very risky, though, as they could completely fail at any point and is not recommended at all. When your axle fails, it’s possible that you’ll lose control of the car, possibly causing an accident or crashing. It’s a far better choice to have the problem diagnosed and repaired now, rather than trusting to chance.
How to take an axle out of a Mazda 6?
If you’re having trouble taking out the CV axle, use a 15mm socket to dismount the strut tower from the lower control arm. This will free up some room for the axle to come out. 9.
Take the 17mm bolt you remove and thread it into the other side of the spindle. Then take a flat, thin piece of metal and insert it into the slot at the back. Then thread in the bolt more and more so it pushes against the piece of metal you used.
Where is the CV axle nut on a Mazda 6?
The CV axle nut is located in the middle of the hub. If the nut is difficult to remove due to rust or something else, use a rust penetrant. Gather together a pry bar, breaker bar, and 32mm socket. Use the pry bar to hold the rotor in place, connect the socket and breaker bar to the lug nut, and then push down the breaker bar with your foot. 4.
How is the axle held in on a car?
The axle is held in by a C-clip on the splines. All you have to do is hammer it out. It makes it significant easier if you have a large punch to use. Here’s where the intermediate shaft on the left and the axle on the right connect.
When to replace a CV joint on a motorcycle?
If it’s the CV joint I know it’s going to need replacing regardless, so I’m planning on driving it until it gets worse or until it gets warm enough that I can comfortably ride my motorcycle to work for a couple days while it’s getting fixed.
When to replace CV axle on Mazda 6?
A bad CV axle means a stranded car. Put your Mazda 6 back on the road by replacing your axle assembly as soon as possible! Skip the dealership and do it at home with this tutorial.
Who is responsible for damage to a Mazda 6?
All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
If it’s the CV joint I know it’s going to need replacing regardless, so I’m planning on driving it until it gets worse or until it gets warm enough that I can comfortably ride my motorcycle to work for a couple days while it’s getting fixed.