Can a converter standalone client connect to a local machine?
When you install the Converter Standalone server and the Converter Standalone client, you can use the local machine to access remote Converter Standalone servers or create conversion jobs locally. If you install only Converter Standalone client, you can connect to a remote Converter Standalone server.
What happens when I install converter standalone server?
When you install the Converter Standalone server and Remote access, the local machine becomes a server for conversions, which you can manage remotely. When you install the Converter Standalone server and the Converter Standalone client, you can use the local machine to access remote Converter Standalone servers or create conversion jobs locally.
How to install converter standalone from the command prompt?
You can use the command-line installation options when you install Converter Standalone from the Command Prompt in Windows or by writing a Windows batch file ( .bat ). [Read more]
How to install a line output converter ( Loc ) to any car?
You can follow this guide if you are installing the line output converter to the rear speakers or to the cars wiring harness. Make sure to splice the wires like shown and match the cables from the LOC to your specific car.
How do you install a line output converter?
Connect your battery and turn on the stereo to ensure the amplifier, stereo, and speakers are working as expected. Make any necessary adjustments, if needed, and proceed to finalize your install. Clean up all wiring, secure the line output converter, and reinstall the stereo.
How do you install a converter on a transmission?
Install converter on transmission carefully, supporting the weight of it to avoid damage to the front pump seal. Rotate converter as you push it on. The splined couplings (input shaft and stator support) and the pump lugs must engage properly to allow the converter to slide all the way onto the transmission.
Can a torque converter be installed the wrong way?
Input shaft can at times pull out with converter. Try to avoid this. Because some Ford input shafts can only be installed one way due to spline length difference, installing shaft the wrong way will damage converter. Check with local Ford service department for correct installation.
What should cooler line fittings be tightened to?
Step 6 Cooler line fittings must be tightened to 12 ft/lbs. Use caution, over-tightening can cause transmission case to burst at fittings. Do not use teflon tape.