Can a 1997 Suzuki dl25 hp idle under load?
I purchase a 1997 Suzuki DL25 HP and I have cleaned the carbs and all the jets , it will idle with no problem but not operate under load ,I also would … Tilt and Trim motor runs in the down position when the key is on.
What to know about your Suzuki outboard engine?
Are you looking for good advice about your Suzuki outboard engine problems and issues. All you need to know about your outboard engine issues and good advice from your fellow boaters. From outboard engine and electrical and electronics systems to engine and alarm issues, tilt and trim issues, this is the place to find information.
What to do if your Suzuki outboard motor is not starting?
Common problems in Suzuki outboard motors can be easily diagnosed from home. Inspect the primer bulb if the engine is not starting. If there is no resistance, fuel is not entering the engine. The primer bulb and entire fuel line may have to be replaced.
How long has my Suzuki outboard been in storage?
Motor only has 5 hours on it and has been in storage for 8 years. I cleaned the old fuel out, replaced filters and fuel pump which bench tested as bad. …
Why does my outboard engine keep spitting water?
The tell-tale isn’t spitting water. This could result from a ruined water pump impeller, which will require service. But more often than not, the issue arises because the tell-tale is clogged with grit, mud, or a bit of seaweed the engine picked up.
Why does my outboard motor run at high speed but not idle?
When an outboard motor runs at speed but cannot hold an idle, it usually indicates a problem with the carburetor. Outboard motor designs vary depending on make and model, but all operate on similar principles. Consult your owner’s manual to check items that may be unique to your motor.
What to do if your Suzuki Eiger won’t start?
Turn the ignition and start the Suzuki Eiger. If the engine has difficulty starting or will not start at all, there may be a problem in the electrical or starting system. Remove the spark plug wire from the spark plug and remove the spark plug from the engine using a spark plug wrench.