Can a 1982 XV750 be turned into a Bobber?
1982 XV750 Lots of extra parts, has been turned into a bobber, Has been painted red since the main picture. Brand New tires, with extra set still in great shape. Was running but the push rods are bent, Have new piston rings, extra frame and handlebars extra set of carbs, Serious inquiries only please.
What did the previous owner of a triumph bobber do?
Just used it for its unique history and hand built parts for people to admire. Previous owner/builder used it for off road scrambles and hill climbing in Southern IL. and Indiana back in the 1970’s and early ’80’s. Fuel tank is divided in half (left side oil tank/right side fuel). Custom seat section for better off road handling.
What kind of engine does a 1973 Triumph bobber 750 have?
1973 TRIUMPH BOBBER 750, 5 SPEED, HAS AMENS SAVIOR FRAME. A COMPLETE REBUILD ON ENGINE, BORED 20 OVER, CARBS REBUILT, NEW BOYER IGNITION 12 VOLT TWIN OUTPUT COIL IGNITION, HIGH OUTPUT STATOR, NEW CUSTOM SEAT, NEW PAINT JOB, TIRES ARE GOOD, BRAKES ARE NEW, EVERY COMPONENT ON THIS BIKE HAS EITHER BEEN GONE THROUGH OR REBUILT.
Who are the people who make Pazon ignitions?
Ignitions made by people who love classic bikes as much as you do. From the management and technical team that successfully ran Boyer Bransden until 2004, when they decided to forge their own path. Pazon felt that classic bikes and their owners deserved a higher quality product and service.
How to troubleshoot a Boyer ignition control box?
To see typical coil resistances click here. If the bike is running on one cylinder this is not a problem caused by the Boyer control box. Check each coil, plug wire, and spark plug individually. To individually check each coil, you will need to rewire the Boyer box wiring (black and red wires) so they go to one coil.
When was the first Boyer Bransden ignition made?
The first commercially produced Boyer-Bransden electronic ignition was launched in 1969 for Boyer of Bromley, a then famous motorcycle dealership whose Triumph race team were experiencing trouble with the points on their race bikes. They proved an instant success.
What kind of resistance does a Boyer ignition have?
Two 12-volt Taiwan coils in series will have approximately 9 ohms resistance. Over tightening coil brackets may cause the coil primary windings to short (the meter will show a lower resistance than expected). This will cause the coil to draw a lot of current through the control box. It is common for the box to fail after such an event.
Can a Boyer ignition be installed on a triumph?
This unit will work on Triumph and BSA 500 / 650 / 750 c.c. bikes with 12 volt systems. You can find install instructions for the Boyer Electronic Ignition for Triumph and BSA Twins below.