Are there any major problems with the L5P duramax?
Mechanically, the L5P Duramax is stout and very few major problems have been reported. One common problem is with the MAP sensor however, as it tends to clog with soot and throw a check engine light, but a simple MAP sensor spacer and a can of electrical cleaner can get you back on the road worry free and prevent the soot from building up again.
Why is my Duramax diesel engine not working?
The trucks computer keeps track of how much fuel needs to be added or subtracted from each individual cylinder to make the engine run smoothly, and this value is called the balance rate. If one cylinder is contributing too much or not as much as the rest, the cause is usually a bad injector and the cure is a replacement.
What’s the best way to reset a check engine light?
In such a case, it is highly recommended to check the codes with a scanner instead. Switching the ignition on and off is also one method of hard reset without disconnecting batteries. Put the keys in your ignition and turn your ignition on and off consecutively after a second in each step.
What makes a Duramax LB7 diesel so special?
The introduction of common rail injection powered by the Bosch CP3 injection pump made the LB7 Duramax stand apart from other diesels of the day with excellent power and efficiency.
What’s the Check Engine light on a Duramax?
Started up fine. Only thing i noticed was that the oil pressure was pegged out at 120 and the battery was around 10 or 11 marker on the gauge. Ran and drove fine. Keep in mind the temp was around 18F this morning when i left for work. You will need a scanner to pull the codes.
Why does my check engine light go out?
Took it for a scan and the P133F code showed up 3 times. After a couple on/off’s throughout the day, the light went out again. This morning (Tues) i did a remote start and it fired up just fine and the check engine light is out.
What is glowplug fault on GMC Duramax Diesel?
P133F is #8 glowplug hot resistance fault. Did you determine if the Elevated Idle is enabled? Are you using remote start? If not, are you giving waiting for glowplug light to go out before turning key to ‘start’? Elevated idle was not activated….it is now though.
Why does my GMC Duramax have high oil pressure?
High oil pressure at cold weather start up is normal for these engines. Remote start and a little time letting the Elevated Idle function do it’s thing before driving the truck goes a long way to warming the oil enough start the pressure drop process.