How often should you change your differential fluid Jeep Wrangler?

How often should you change your differential fluid Jeep Wrangler?

every 15,000 miles
Following “Schedule B” in the Jeep owner’s manual (heavy driving), you should change your differential fluids every 15,000 miles. However it is always a good idea to do this IF you’ve submerged your axles in deep water for prolonged periods of time.

How do you change differential fluid on a jeep?

Based on Internet research, it appears there’s several tenths of a quart difference from Jeep to Jeep. Use your best judgment. Place the drain pan below your differential. Attach the ratchet extension to the 3/8-inch ratchet and insert the head of the extension into the bolt hole on the front of the differential cover.

What kind of differential oil does a Jeep Wrangler use?

This is according to the Jeep Wrangler maintenance schedule. There are two types of differential oils that are suitable for Jeep vehicles, namely Royal Purple, Pennzoil, Valvoline and Amsoil. The Jeep forum states that you can use Royal Purple 90 for the front differential and 140 for the rear.

How often should I change the oil in my Jeep JK?

What a diff-erence! Changing Jeep JK differential fluid According to Jeep, the gear oil in Smokey’s front and rear differentials should be changed about every 15,000 miles, based on the “heavy driving” maintenance schedule.

Where do you put the fill plug on a jeep differential?

If you are servicing a Dana 30 or Dana 44 differential on your Jeep, place place an oil catch pan underneath the differential and then use the square head of a 3/8″ drive ratchet to remove the fill plug on your differential cover.

How to change differential fluid in Jeep Wrangler?

(Playback ID: lmlNaJOIKNKbEkrF) An error occurred while retrieving sharing information. Please try again later.

How do you change axle fluid on a jeep Dana?

On Dana 30 and Dana 44 axles, reinstall the fill plug bolt back onto the differential cover and then tighten it down to 25 ft. lbs. of torque. 13b. On Dana 35 and Chrysler 8.25 axles, simply reinsert the rubber plug back into the fill hole on the differential cover. That should be it for the rear end.

If you are servicing a Dana 30 or Dana 44 differential on your Jeep, place place an oil catch pan underneath the differential and then use the square head of a 3/8″ drive ratchet to remove the fill plug on your differential cover.

What to do when your Jeep differential droops?

This will cause your axle to droop allowing you easier access to the upper differential cover bolts. 2a. If you are servicing a Dana 30 or Dana 44 differential on your Jeep, place place an oil catch pan underneath the differential and then use the square head of a 3/8″ drive ratchet to remove the fill plug on your differential cover.