Where is the ABS controller located on a car?
ABS Brake Control Module Replacement The ABS controller is used to monitor the wheel rotation speed and can go out as electronics sometimes do. This computer module is located on top of the pump motor and is attached by four or five mounting bolts.
How do you remove an ABS module from a car?
Unbolt whatever bracket or bolts are used to mount the ABS module and solenoid block to the car. This configuration will greatly depend on the make and model of car you are working on. Step 5: Remove the ABS module from the solenoid block. Remove the bolts that attach the module to the solenoid block. Gently pry the module from the block.
Do you need to remove flare end of ABS control module?
Make sure all the brake lines are tight and the flare end is firmly seated as you tighten the brake lines. Sometimes, this can be an issue. If it is, you will need to remove the leaking brake line and take a closer look at the flared end.
When do you Know Your ABS module is bad?
The whole purpose of an ABS control module is to prevent locking of the wheels. If you notice that your wheels are locking up while you’re driving, then this obviously means that your ABS control module is faulty or damaged. Generally when an ABS module fails, you will only notice when you slam on the brakes.
Is there an ABS module for the Jeep Grand Cherokee?
We offer a full selection of genuine Jeep Grand Cherokee ABS Control Modules, engineered specifically to restore factory performance. Please narrow the Anti Lock Brake Control Module results by selecting the vehicle.
Where is the ABS control module located on a car?
Locate the ABS control module. It is generally installed in the engine compartment or in the frame rail on the driver’s side. If the module is located in the latter position, you will need a jack stand to lift the vehicle to continue replacing the module.
Do you need to replace the ABS control unit?
In some vehicles, the ABS control unit is shared with the traction control system. In that case, you should choose a new replacement ABS control module that is designed to control the traction system, as well. After the ABS control module is repaired, it is advised to flush the brake system with fresh brake fluid.
Where is the fuse box on a Jeep Grand Cherokee?
It is located behind the lid under the glove compartment. Back-Up Lamp Switch (Diesel), Vehicle Information Center, Graphic Display Module (Mini Overhead Console), Park/Neutral Position Switch, Speed Proportional Steering Module, Headlamp Leveling Switch, Combination Flasher, Automatic Day/Night Mirror, Overhead Console