Why is my Jeep Grand Cherokee door lock not working?

Why is my Jeep Grand Cherokee door lock not working?

I pushed the black boot between the door jam back and found the power wire broke (orange w/black tracer)fixed it but it st up lol is not working. I did the battery thing for 30 min also. Still nothing. I’m losing my mind here. 18 people found this helpful. My 2004Jeep Grand Cherokee driver door locks and all windows stopped working.

Why are the windows on my Jeep Laredo not working?

95 Grand Cherokee Laredo 5.2 had no windows working, looked at drivers door and spliced split black wire together and the 2 drivers windows work! The passengers will not move from either control? Check all fuses. Do you think it’s the switches on just the right side? Or maybe a fuse in the engine box? 24 people found this helpful.

How to troubleshoot a Jeep XJ Cherokee problem?

“If the power lock system is inoperative with either front door power lock switch, test the Passenger Door Module (PDM)…If the power lock system is inoperative with only the driver side front door power lock switch, test the Driver Door Module (DDM).” I can help you troubleshoot beyond these symptoms, too.

Are there any problems with my 2008 Jeep Grand Cherokee?

Have a 2008 grand Cherokee the front windows and door locks stop working the tailgate won’t open and my gauges on the dash stop working. But my back windows work fine the truck runs fine what could be the problem ?

Why does my Jeep Grand Cherokee not lock?

Here’s the problem: the rear liftgate door usually doesn’t respond to the lock/unlock key. I went four days straight with being unable to get the liftgate to lock, even though all the other doors work fine. I would stand by the liftgate pressing the “lock” mode on the remote key fifty times- no response.

What can I do about the rear door latch on my Jeep Cherokee?

You can loosen the Torx screw and move the lever/button adjuster to allow for a full throw of the outside handle button when you press the button. This and some white lithium spray lube at pivot points of the latch mechanisms can have your “defective” rear door latches functioning as new!

Why is my Jeep Grand Cherokee going limp home?

It sounds as if the transmission has gone into the “limp home” mode, which usually is due to a malfunctioning sensor input to the transmission. However, the dealer should be able to find a code quickly from the OBD computer. It shouldn’t take days to do that. The 8/4 (MDS) almost certainly has nothing to do with the problem. . Does not Work 1.

Where are the fuses in the Jeep Grand Cherokee?

The video above shows how to replace blown fuses in the interior fuse box of your 2011 Jeep Grand Cherokee in addition to the fuse panel diagram location. Electrical components such as your map light, radio, heated seats, high beams, power windows all have fuses and if they suddenly stop working, chances are you have a fuse that has blown out.

Why are power windows, locks and mirrors not working?

The power windows, locks and mirrors are not working on my vehicle. I cannot find any fuse, breaker or relay that is labeled in the interior fuse box or power distribution center in the engine compartment for these circuits. Can you give their location and name? have the same problem?

Can a power window motor go bad on a jeep?

Had that happen with windows on my 99 laredo 4.7 QD. The main control module went bad on drivers side. Power window motor went on passenger door. Main control module was $240 list my chrysler emply. price was 170 which was still pricey. Had a buddy install them every was fine after that.

I pushed the black boot between the door jam back and found the power wire broke (orange w/black tracer)fixed it but it st up lol is not working. I did the battery thing for 30 min also. Still nothing. I’m losing my mind here. 18 people found this helpful. My 2004Jeep Grand Cherokee driver door locks and all windows stopped working.

95 Grand Cherokee Laredo 5.2 had no windows working, looked at drivers door and spliced split black wire together and the 2 drivers windows work! The passengers will not move from either control? Check all fuses. Do you think it’s the switches on just the right side? Or maybe a fuse in the engine box? 24 people found this helpful.

What was the problem with my Jeep Grand Cherokee?

2004 Jeep grand cherokee power door locks and windows stopped working. found the problem and fixed it. Also the interior lights would not turn off and the jeep did not register as an open door. the FoB lock would not work either. Loading…

The power windows, locks and mirrors are not working on my vehicle. I cannot find any fuse, breaker or relay that is labeled in the interior fuse box or power distribution center in the engine compartment for these circuits. Can you give their location and name? have the same problem?

Why are my power windows not working on my Jeep Grand Cherokee?

While some other SUVs were manufactured with body-on-frame construction, the Jeep Grand Cherokee has always used a unibody chassis. Why won’t my power Windows work? I have a 1999 jeep grand Cherokee with the v8 engine and none of my Windows will go up or down.

Why does my Jeep side window not roll up?

From the inside, there is no clicking and no green arrow. NOTHING happens. Its doesn’t appear to be affecting the light itself, hazards are fine and brake and tail lights are fine. 2. After that started occurring, now the drivers side window will not roll up.

Is the power door lock on a Jeep Grand Cherokee working?

This feature is not available right now. Please try again later. 2004 Jeep grand cherokee power door locks and windows stopped working. found the problem and fixed it. Also the interior lights would not turn off and the jeep did not register as an open door. the FoB lock would not work either. Loading…

Why are my Jeep Grand Cherokee windows not working?

My 2004Jeep Grand Cherokee driver door locks and all windows stopped working. I found the black 10/12 gage wire and a yellow 18 gage wire broken in two within the driver side black boot covering the harness into the car body. I stripped and butt spliced both wires.

Had that happen with windows on my 99 laredo 4.7 QD. The main control module went bad on drivers side. Power window motor went on passenger door. Main control module was $240 list my chrysler emply. price was 170 which was still pricey. Had a buddy install them every was fine after that.

What to do if your power door lock is not working?

If fuse is ok, i would first check the wires in the boot between the door and the body for any broken wire. If this is ok, you will have to measure on the window motor connector to see if power is there. Regarding the hatch door lock, there most probably the lever connecting the actuator to the actual lock has become loose.

If fuse is ok, i would first check the wires in the boot between the door and the body for any broken wire. If this is ok, you will have to measure on the window motor connector to see if power is there. Regarding the hatch door lock, there most probably the lever connecting the actuator to the actual lock has become loose.

Is there a problem with my Jeep garage door?

After some searching on the internet i found out that this problem happened already with quite some other WJ’s. Most of the time the black ground wire in the rubber boot between the door and the body breaks. Sometimes the orange wire breaks.

What’s the problem with my 1998 Jeep Cherokee?

1998 jeep Cherokee classic has door locking/unlocking problem. sometimes they work and sometimes they don’t. passenger door lock makes a ticking noise when I push the door lock on drivers door. nothing will lock or unlock electronically. any help on how to fix would be very helpful. oldman44oldjeep98, May 1, 2018.

How to fix power windows on Jeep Cherokee?

Not just by jumping a wire in the kick panel that disables the lock-out button. This regains full use all passenger windows as well as keeping the child safety button functional when needed. This will also fix power locking and RKE issues when the re-flowing procedure in the video is done to the PASSENGER side module.

While some other SUVs were manufactured with body-on-frame construction, the Jeep Grand Cherokee has always used a unibody chassis. Why won’t my power Windows work? I have a 1999 jeep grand Cherokee with the v8 engine and none of my Windows will go up or down.

What causes a door lock to stop working?

If the door lock relay has any internal or wiring issues, it can cause the door locks to function intermittently. The door locks may function correctly one moment, and in the next will cease to operate.

What happens if you have a bad door lock relay?

However, vehicles without door lock cylinders will not be able to lock or unlock the doors until power is restored. For vehicles with traditional style door lock cylinders and keys, a bad power door lock relay will merely disable the power door lock feature.

Where are the power buttons on the side of the door?

Look for the toggle switch on the overhead console by the other buttons. The power buttons located on the inside of the doors in the middle row on both the driver and passenger side stopped working. The overhead console switches still work for them as does the remote.

If the door lock relay has any internal or wiring issues, it can cause the door locks to function intermittently. The door locks may function correctly one moment, and in the next will cease to operate.

However, vehicles without door lock cylinders will not be able to lock or unlock the doors until power is restored. For vehicles with traditional style door lock cylinders and keys, a bad power door lock relay will merely disable the power door lock feature.

Look for the toggle switch on the overhead console by the other buttons. The power buttons located on the inside of the doors in the middle row on both the driver and passenger side stopped working. The overhead console switches still work for them as does the remote.

Why does my Dodge Caravan doors not work?

If you get to a point where most functions work, but one doesn’t then you’ve probably managed to actually break a wire in the harness. This can manifest as something like locking or unlocking no longer working, or open/close not working, while other things still work.