How do you reset the low tire pressure light on a Jeep Grand Cherokee?
Find the VEHICLE INFO menu by pressing the UP or DOWN arrow button on the steering wheel until You see Tire Pressure and then press the RIGHT button. Use the buttons on the steering wheel again to reset it and then turn the vehicle off and then start it and drive for about 20 minutes above 16 mph.
Where is the TPMS reset button on a 2015 Jeep Cherokee?
You can perform a TPMS reset for Your 2015 Jeep Cherokee by first of all turning Your key to the ON position. Make sure that the car doesnt start while doing this. Now, press and hold the TPMS reset button on Your vehicle. This button is usually located under the steering wheel.
Where is the TPMS reset button on a Jeep Grand Cherokee 2010?
Locate the TPMS reset button under the steering wheel and press in, holding until the tire pressure light blinks three times. Start the car and wait 20 minutes for the sensor to refresh.
How can I reset the tire pressure on my Jeep?
Disconnecting the battery will not “reset” the TPMS (nor will unhooking the battery cause other issues). Temporarily raise the pressure in the offending tire above the threshold, to ~40 PSI. Then return it back to the placard pressure.
How to reset the tire pressure light at home?
How to reset tire pressure light 1 Make Sure You Have the Correct Pressure. Before you try to reset your TPMS light, you should always ensure that you have the right tire pressure in your vehicle. 2 Use the Car’s TPMS Reset Button. 3 Remove and Re-Connect the Car Battery. 4 Use a TPMS Reset Tool for Your Vehicle. …
Where is the reset button on a Jeep Wrangler?
Front right tire reading was stuck, now showing a — , along with the TPMS error light. Tire pressures are all good. Trying to do a TPMS reset and can’t find the reset button that is supposed to be located under the steering wheel on the right side.
How do you reset the TPMs on a Jeep Cherokee?
Press and hold the RESET button for 10 seconds. You have successfully reset the TPMS on the Jeep Cherokee. **NOTE: Should the low-Pressure warning remain after your first try, repeat the steps. If you are still unsuccessful, contact the dealership for assistance or consult your vehicle user’s manual.
How to reset tire pressure system in Jeep Cherokee?
Drive above 15mph/24km for 20 minutes within the city to reset your system. Switch the ignition to the ON position without starting the vehicle. Press gas all the way to the floor 3x’s within 10 secs. Switch OFF ignition. After 10 secs start the engine. Switch the ignition to the ON position without starting the vehicle.
Is there a way to reset the tire pressure light?
While the tire pressure light should turn off on its own after properly inflating your tires, there are additional steps available for a reset if needed: For about 10 minutes, drive at or above 50 mph. The next time you restart your car, it’s likely the sensor will reset. Turn the key to the “On” position, but don’t start the car.
How to reset service on a Jeep Grand Cherokee?
Use the STEP button on your center console pressing it till the MILES TILL SERVICE is displayed. 3. Press and hold the RESET button to the left of the STEP button for 4 seconds. Loading…
What does the TPMs do on a Jeep Cherokee?
Jeep Cherokee’s are equipped with a TPMS (Tire Pressure Monitoring System) to assist you in maintaining the correct tire pressure. The warning low-pressure indicator light which appears within your dashboard or via the EVIC, indicated by a chime, should turn off automatically after your tires receive the proper amount of air pressure/ PSI.