How do you reset the oil change light on a 2008 Jeep Grand Cherokee?

How do you reset the oil change light on a 2008 Jeep Grand Cherokee?

To reset the 2008 Jeep Grand Cherokee Oil Change Interval, please follow these instructions:

1. Turn the ignition to run (one position before starting engine).
2. Fully depress the accelerator pedal slowly three times within 10 seconds.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How do you reset the oil life on a Jeep Grand Cherokee?

fully depress the accelerator pedal slowly three times within 5 seconds and the OIL LIFE is reset

1. fully depress the accelerator pedal slowly three times within 5 seconds and the OIL LIFE is reset.
2. Turn off the ignition, then start the engine normally and the light should be reset.

How do you reset the oil light on a 2009 Jeep Grand Cherokee?

Reset Guide: Jeep Grand Cherokee Oil Change Light (2009-2021)

1. Place the ignition to the RUN position without starting the engine.
2. Fully depress the GAS pedal, three times within 10 seconds.
3. Turn off the ignition.
4. Verify the indicator has been reset by starting the engine.

How to reset the oil service light on a Jeep Grand Cherokee?

fully depress the accelerator pedal slowly three times within 5 seconds and the OIL LIFE is reset Turn off the ignition, then start the engine normally and the light should be reset. About Jeep Grand Cherokee The Jeep Grand Cherokee is a range of mid-size SUV’s produced by the American manufacturer Jeep.

How to reset the oil change maintenance light?

Turn ignition to RUN position, don’t start the engine. fully depress the accelerator pedal slowly (3x) THREE TIMES within 10 seconds. Turn the ignition off and then start the engine to verify the indicator has been reset.

How to reset maintenance light on Jeep Wrangler?

1 Close all doors, gear in Park position. 2 Turn the ignition to RUN position, don’t start the engine. 3 Use the NAVIGATION button, navigate to VEHICLE INFO then scroll to REMAINING OIL LIFE. 4 Turn of the ignition.

How to change the oil in a Jeep Wrangler?

Turn the ignition to the “RUN” position. Immediately press and release the accelerator pedal 3 times within 10 seconds. Turn the ignition off. The 3.8 liter engine holds approximately 6 quarts (5.7 liters) of 5W-20 oil when the engine oil and filter are changed.

fully depress the accelerator pedal slowly three times within 5 seconds and the OIL LIFE is reset Turn off the ignition, then start the engine normally and the light should be reset. About Jeep Grand Cherokee The Jeep Grand Cherokee is a range of mid-size SUV’s produced by the American manufacturer Jeep.

1 Close all doors, gear in Park position. 2 Turn the ignition to RUN position, don’t start the engine. 3 Use the NAVIGATION button, navigate to VEHICLE INFO then scroll to REMAINING OIL LIFE. 4 Turn of the ignition.

Turn ignition to RUN position, don’t start the engine. fully depress the accelerator pedal slowly (3x) THREE TIMES within 10 seconds. Turn the ignition off and then start the engine to verify the indicator has been reset.

How to reset oil service Light Dodge Grand Caravan?

Fully depress the accelerator pedal slowly three times within 10 seconds. Turn the ignition switch to the OFF/LOCK position. NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary repeat this procedure.