How do I add an amplifier to my Jeep stereo?
If you do not have a factory amplifier installed, then you can either interface at each rear speaker and tap into the lead there, or you can interface with the speaker output wires at the receiver (recommended). Again, refer to the link below to figure out which color wires to interface with.
How do you connect a radio to an amplifier?
Connect the end coming from the radio plug to a new wire going to the amp’s input. Connect the end going to the speakers to the appropriate wire coming from the amp’s output. That means you’ll use two of the 9-wire cables, one for the amp’s input, the other for its output.
How do you hook up an amp gauge to a car?
Place the wires into the hole at the end of the insertion tool’s handle and push them through completely. Go inside your vehicle and pull the ends of the wires so you have 6–7 feet (1.8–2.1 m) to work with. When you connect to the amp gauge, you’ll use 1 red wire and 1 black wire that will both carry a current.
How to install an aftermarket radio in a 1999-2004 Jeep?
Here’s what you’ll need to install your aftermarket radio into your 1999-2004 Jeep Grand Cherokee: Parts you’ll need to purchase: – (1) Aftermarket Single-DIN Radio (a double-DIN aftermarket radio WON’T fit into your Jeep’s dash).
If you do not have a factory amplifier installed, then you can either interface at each rear speaker and tap into the lead there, or you can interface with the speaker output wires at the receiver (recommended). Again, refer to the link below to figure out which color wires to interface with.
How to add a speaker to a Jeep Grand Cherokee?
Attach the new speaker to the mounting bracket, connect the wiring harness to the speaker, then plug it into the Jeep’s wiring connector. Secure the new speaker assembly to the door with the Phillips screws. Test the speaker, then reassemble the door panel.
What kind of stereo system does a Jeep Grand Cherokee have?
The Grand Cherokee was available with two different stereo packages. The base system was an AM/FM/cassette player and six speakers (front and rear doors, and dash tweeters).
How do you connect an amplifier to a car stereo?
Refer to your amplifiers manual to connect your high-level inputs. You will likely use four wires from a full range speaker (s); Right rear speaker (+), Right rear speaker (-), Left rear speaker (+), Left rear speaker (-). This will provide a full-range signal for your amplifier.
Where is the power wire on a jeep?
Some Jeeps have a spare/unused grommet in the fire wall that can be used as a pass through for your power wire. If you do not have a spare grommet, you can piggyback through another grommet or drill a hole and make your own.
How do I add an amplifier to my car?
Use a site like www.crutchfield.com to figure out which adapter will fit your vehicle/radio. The aftermarket amplifier will require a run of power wire from the vehicles battery, located under the hood, to the aftermarket amplifier.
Some Jeeps have a spare/unused grommet in the fire wall that can be used as a pass through for your power wire. If you do not have a spare grommet, you can piggyback through another grommet or drill a hole and make your own.
Use a site like www.crutchfield.com to figure out which adapter will fit your vehicle/radio. The aftermarket amplifier will require a run of power wire from the vehicles battery, located under the hood, to the aftermarket amplifier.