How to replace rear shock and spring on Jeep Grand Cherokee?
Anyway, let’s start with how to replace the rear shock and spring (while we are there, we will replace the sway bar extension. Wrench with sockets as follows: 15mm, 17mm, 18mm and 19mm. Flat screw driver. 2 Jack stands. Spring compressor would be a “nice to have” and will make the work easier. Let’s start working…
Where are the shocks on a 1998 Jeep Cherokee?
On a 1998 Jeep Cherokee, the shocks are relatively easy to repair with a few tools. Lift the hood of the vehicle and locate the upper locking nut. It will be on the vehicle’s inner fender well attached to the upper shock stud. Loosen and remove the locking nut from the upper shock stud on both sides of the vehicle, using a wrench.
How do you install new shocks on a car?
Place the new shocks on the vehicle. Install the rubber and metal washers on the lower shock studs on both sides, then install the nuts, turning it only a few threads. Guide the upper studs through the holes in each fender well. Place the two washers on the upper stud on each shock. Hand-tighten the upper nut.
How do you replace rear coil on Jeep Grand Cherokee?
If you have new isolators, remove the old isolators using a flat screwdriver, clean the mounts. Install the new isolators, notice the pin/hole and install it according to them.
Anyway, let’s start with how to replace the rear shock and spring (while we are there, we will replace the sway bar extension. Wrench with sockets as follows: 15mm, 17mm, 18mm and 19mm. Flat screw driver. 2 Jack stands. Spring compressor would be a “nice to have” and will make the work easier. Let’s start working…
If you have new isolators, remove the old isolators using a flat screwdriver, clean the mounts. Install the new isolators, notice the pin/hole and install it according to them.
How do you raise the front axle on a Jeep Cherokee?
Raise the front axle of the Cherokee with the floor jack and place the jack stand under the axle tube. Repeat for the other side to elevate the entire front suspension. Put on the safety glasses and crawl under one side of the Jeep (on a creeper if you have one) and bring the ratchet and sockets with you.
Where do you put the Jack on a Jeep Cherokee?
secure the front wheels and raise the rear end of the Jeep, I usually locate the jack under the rear diff and raise from there. Put jack stands under the Jeep’s chassis (the “rails frame”), remove the rear wheels and lower the jack.