Why is my airbag light on in my 2005 Jeep Grand Cherokee?
Seat Belts Modern vehicles have sensors running to them to let the computer system know if they are buckled, and if they are locked up. If you have a seat belt that is stuck in the lock position, it might be the reason why your airbag light is on. See if you can tug at it and get it moving again.
Where is the airbag fuse on a 2005 Jeep Grand Cherokee?
Look at the passenger kick panel, pull the cover, and it is #2 fuse (second from the top on the left) The see the relay you may have to pull the panel (two screws and a clip) the relay is the third cavity down, third row from the firewal side.
Is the Jeep airbag module reset by myairbags?
The best part of having your Jeep’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.
Is there a way to reset the airbag light?
The airbag light will often go away by itself after repairing the problem, but not in all car models. After you have installed the new parts and are 100% sure that the parts are installed correctly, it’s time to reset the engine light. To do this – you need to use an OBD2 scanner, and it’s not possible in another way.
Why does the airbag light come on on a Jeep Grand Cherokee?
Your airbag light is part of your Grand Cherokee’s larger supplemental restraint system. It works in tandem with the system to protect you in the event of an accident. If all parts of this system are not working properly, it can cause the airbag light to come on.
Where are airbag codes stored in a jeep?
Below you will find common airbag codes that can be stored in your airbag control module after your vehicle was in an accident. The best part of having your Jeep’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play.
How to reset the airbag light on a 1999 Jeep Grand Cherokee?
How to Reset the Airbag Light on a 1999 Jeep Grand Cherokee. 1 Step 1. Put the key into the ignition and turn it to the “On” position. Do not start the engine. 2 Step 2. 3 Step 3.
Where is the reset light on a Jeep Cherokee?
Put the key into the ignition and turn it to the “On” position. Do not start the engine. Look for a port under the steering column that is the same shape as the plug on your code scanner. Plug the code scanner into the port. The Cherokee’s battery will power the scanner on. Use the arrow keys on the scanner to locate the reset light function.
How can I reset the airbag light on my car?
Repeat the first few steps two more times and you will see that you have reset the airbag light on the dash. You will know that it is reset once the light comes on and turns off. It will not flash. And that’s how you reset an airbag light. If only all your DIY projects could be this easy.
Why does my Jeep Grand Cherokee airbag stay on?
Your Grand Cherokee’s airbag ligh t is there to tell you that there’s a problem with the airbag system. If it comes on for a few seconds as the vehicle starts, that is completely normal and part of the diagnostic cycle. It’s when it stays on that indicates a problem.