Can you drive without doors on a Jeep Grand Cherokee?
It’s legal to drive a Jeep on the road without the doors attached in most states as long as your vehicle remains compliant with laws requiring that vehicles have enough mirrors to see behind the vehicle. This can, however, include half doors and other door alternatives as long as they’re similar to the original doors.
How do you remove a door from a Jeep Cherokee?
Pull the electrical through. Disconnect the door retainer that holds the door open either by hammering the pin upwards, by unbolting it, or by cutting it off. Unbolt the door from the hinges or in the older Jeep Cherokee’s case, cut the hinges with a sawzall.
Can you replace blend doors on a Jeep Grand Cherokee?
Thought I’d share my experience of replacing blend doors on my WJ without removing the entire dash. The tech manuals say you have remove the entire dash to replace the blend doors; you do unless you are willing to make a simple cut with the Dremel tool.
What’s the best way to remove a door panel?
Use the door panel removal tool or a flat blade screwdriver to remove the “Christmas tree” fasteners from the back of the door panel. Grab the door panel firmly and lift up and away from the vehicle.
How much does a Grand Cherokee door repair cost?
This repair cost me $130 and took me about 2 hours. I would have done it much quicker, but the neighbor came over and we stood around BS’ing for awhile. Nice fix for a common problem.
Pull the electrical through. Disconnect the door retainer that holds the door open either by hammering the pin upwards, by unbolting it, or by cutting it off. Unbolt the door from the hinges or in the older Jeep Cherokee’s case, cut the hinges with a sawzall.
How to diagnose and replace Jeep Grand Cherokee blend doors?
This video shows you how to Diagnose and Replace the Blend Doors in a 1999-2004 Jeep Grand Cherokee. Make sure that your specify if your vehicle has two heat zones or just one. New part we installed is designed for one heat zone. This is why it was not necessary to reinstall the blend door partition.
Use the door panel removal tool or a flat blade screwdriver to remove the “Christmas tree” fasteners from the back of the door panel. Grab the door panel firmly and lift up and away from the vehicle.
Why are the doors on my Grand Cherokee not working?
It was a jagged break, so sometimes both doors would catch each other and work properly. Most of the time 1 door would get stuck in a mid position, blending hot air and cold air. Here’s a picture comparing the broken, OEM plastic doors and the new metal doors I ordered.