What is mode control on GM transfer case?
The dash buttons to the right of the air vent identify this system as an NVG 246 automatic two-speed, which means it has DTCs and scan tool capabilities. mode control is a set of normally open switches that vary the voltage supplied by the transfer case module when closed.
Where is the encoder motor on a GM transfer case?
Access to datastream information for GM’s NVG 246 system makes most problems simple to locate and diagnose, as our case studies demonstrate. These systems also allow bidirectional control for many outputs. The encoder motor (arrow) is mounted on the front of the transfer case and is used to lock it into 4WD.
Why does the 4 wheel drive light stop flashing?
The transfer case neutral position needs to be selected before you attempt to engage 4WD. The selected position indicator light will flash until the transfer case completes the shift. When the shift is complete, the indicator light for the selected position will stop flashing and remain ON.
When to use transfer case shift control module?
If no buttons are pressed, and the transfer case shift control module detects a voltage level outside the possible range (approx. 0.5-1.0 volts) for longer than 5 minutes, the transfer case shift control module will set this DTC if a button is held down or sticks for a period longer than 5 min- utes.
The dash buttons to the right of the air vent identify this system as an NVG 246 automatic two-speed, which means it has DTCs and scan tool capabilities. mode control is a set of normally open switches that vary the voltage supplied by the transfer case module when closed.
The transfer case neutral position needs to be selected before you attempt to engage 4WD. The selected position indicator light will flash until the transfer case completes the shift. When the shift is complete, the indicator light for the selected position will stop flashing and remain ON.
Access to datastream information for GM’s NVG 246 system makes most problems simple to locate and diagnose, as our case studies demonstrate. These systems also allow bidirectional control for many outputs. The encoder motor (arrow) is mounted on the front of the transfer case and is used to lock it into 4WD.
If no buttons are pressed, and the transfer case shift control module detects a voltage level outside the possible range (approx. 0.5-1.0 volts) for longer than 5 minutes, the transfer case shift control module will set this DTC if a button is held down or sticks for a period longer than 5 min- utes.
What are the pins on the Black 8 Way Plug?
Pin 1 Input Speed Sensor Ground – This is a violet with light green stripe. It needs to connect to Pin 5 on the black 8 way plug. It completes input speed sensor circuit. Pin 2 Input Speed Sensor Signal – This is a red with black stripe wire. It needs to connect to Pin 1 on the black 8 way plug.
What are the solenoids on the Black 8 Way Plug?
Pin 12 Transmission Solenoid A – This is a white wire. It needs to connect to Pin 3 on the black 8 way plug. The solenoids are used by the TCM to shift the transmission. Pin 13 Transmission Solenoid B – This is an orange with white stripe wire. It needs to connect to Pin 2 on the black 8 way plug.