Why do rear power windows not work on Jeep?

Why do rear power windows not work on Jeep?

The rears are used infrequently compared to the fronts and her switches simply “gunked” up for lack of a better term. It wasn’t electrical or a ground, just needed to be popped out, sprayed with something like contact cleaner, re-installed and they worked again.

What to do if front power window does not work?

The following wiring test determines whether or not voltage is continuous through the body harness to the front switch. 1. Remove the power window switch and bezel. 2. Disconnect wire connector from back of power window switch. 3. Switch ignition to the ON position. 4.

Where are the fuses located in a Jeep Liberty?

The electrical power distribution center is located in the engine compartment near the battery. This power center houses plug-in “Cartridge” fuses that replace in-line fusible links.

How many relays are in a Jeep Liberty?

Engine Compartment Fuse Box Diagram № A Protected Component 1 40 Blower Motor Relay 2 30 Radiator Fan (High Speed) Relay, Radiato 2 40 Radiator Fan (High Speed) Relay, Radiato 3 50 Park Lamp Relay, Daytime Running Lamp, H

What’s the problem with the Jeep Liberty rear window?

For 2002-2006 Jeep Liberty Rear Window. The power windows in the Jeep Liberty are notorious for breaking in this manner. The problem is the design of the mechanism used to move the window. The Liberty uses a plastic window bracket that rides inside of a metal track in the door.

Where is the window regulator on a Jeep Liberty?

Part number SP13001 is for the right rear door and part number SP13002 is for the left rear door. This kit was designed to repair the power window regulator. Manual windows were available in the Liberty, but this kit will not work on a manual window regulator. Which door is right and which is left?

Can a power window motor go bad on a jeep?

Had that happen with windows on my 99 laredo 4.7 QD. The main control module went bad on drivers side. Power window motor went on passenger door. Main control module was $240 list my chrysler emply. price was 170 which was still pricey. Had a buddy install them every was fine after that.

Why are my power locks not working on my Jeep?

There is a combination flasher unit under the drivers side dash, but it acts for turn signals as well hazard lights. It is an electronic controlled relay, so maybe the problem is in there. If it was wire related, the problem should be there for the hazard lights as well.

What should I do if my window won’t roll up?

Reverse jumper probes at the motor connector terminals and window should now move in opposite direction. If window does not move or grunt, replace the motor. If window moved completely up or down, reverse the jumper probes and cycle window to the opposite position to verify full operation.

The rears are used infrequently compared to the fronts and her switches simply “gunked” up for lack of a better term. It wasn’t electrical or a ground, just needed to be popped out, sprayed with something like contact cleaner, re-installed and they worked again.

The following wiring test determines whether or not voltage is continuous through the body harness to the front switch. 1. Remove the power window switch and bezel. 2. Disconnect wire connector from back of power window switch. 3. Switch ignition to the ON position. 4.

Reverse jumper probes at the motor connector terminals and window should now move in opposite direction. If window does not move or grunt, replace the motor. If window moved completely up or down, reverse the jumper probes and cycle window to the opposite position to verify full operation.

Can you reset the up / down window on a jeep?

Yes, you can reset it but the problem will keep recurring unless you have the TSB performed. As 5253 pointed out, sooner or later you’ll have to have the TSB performed. On most 08’s, it’ll just be a reflash. A much higher percentage of the 06 and 07 required motor replacement as well.

When do you replace the front window regulators on a Jeep Commander?

I dont remember off hand but I will post a tech note that I have about certain build dates that if one window auto reverses then you are to replace both front window regulators and now flash the door modules. Grand Cherokee and Commander vehicles that were built between 2-12-2007 and 10-3-2007.

Posted In Q&A