How do you remove the drum brake on a jeep?
Starting with the driver side drum brake, use a pair of needle nose vice grips to clamp on, unhook and remove your Jeep’s brake shoe spring. 6. Using a pair of needle nose pliers, lift up and remove your Jeep’s brake shoe adjuster lever spring. 7.
Can you adjust the brakes on a jeep TJ?
The rear drum brakes on a Jeep TJ have been designed with a self-adjusting mechanism. Typically, no adjustments are needed to the brakes unless you have just replaced the drums, shoes or have removed the shoes for other reasons. Below are instructions on how to adjust your rear drum brakes using a brake spoon adjuster tool.
How do you remove a parking brake strut?
Your Jeep’s drum brake adjuster screw is loosely held in by compression. Carefully spreading your Jeep’s brake shoes apart will allow you to remove it with ease. 16. Again, carefully spread apart your Jeep’s brake shoes enough to remove the parking brake strut and springs.
How can I adjust my rear drum brake?
Below are instructions on how to adjust your rear drum brakes using a brake spoon adjuster tool. 1. Place a floor jack underneath the differential of your rear axle and raise it high enough so that the tires are lifted off the ground a bit.
Starting with the driver side drum brake, use a pair of needle nose vice grips to clamp on, unhook and remove your Jeep’s brake shoe spring. 6. Using a pair of needle nose pliers, lift up and remove your Jeep’s brake shoe adjuster lever spring. 7.
The rear drum brakes on a Jeep TJ have been designed with a self-adjusting mechanism. Typically, no adjustments are needed to the brakes unless you have just replaced the drums, shoes or have removed the shoes for other reasons. Below are instructions on how to adjust your rear drum brakes using a brake spoon adjuster tool.
Below are instructions on how to adjust your rear drum brakes using a brake spoon adjuster tool. 1. Place a floor jack underneath the differential of your rear axle and raise it high enough so that the tires are lifted off the ground a bit.
Where can I buy brake shoes for my Jeep TJ?
You can find and purchase drum brake shoes, replacement hardware/spring kit, and all the other tools you need to service your Jeep TJ’s rear brakes at Autozone, Kragen, Napa and Pepboys. If needed, most of these stores should be able to resurface your old brake drums if needed for a small fee.
You can find and purchase drum brake shoes, replacement hardware/spring kit, and all the other tools you need to service your Jeep TJ’s rear brakes at Autozone, Kragen, Napa and Pepboys. If needed, most of these stores should be able to resurface your old brake drums if needed for a small fee.
Can you replace the brakes on a 1994 Jeep Cherokee?
The rear brakes on the 1994 Jeep Cherokee are drum brakes. Replacing the brakes involves removing old brake shoes and installing new ones. Depending on wear, the brake drum may need to be resurfaced or replaced. When servicing brakes, it is important to complete the job on both wheels. Never replace the brakes on only one side of an axle.
Is the rear drum brake on a Jeep Cherokee?
(Playback ID: eJbO18XE_JLnUxwo) An error occurred while retrieving sharing information. Please try again later.
How do you remove a brake shoe from a Jeep Cherokee?
Reach behind your Jeep’s drum brake backing plate and press on the hold down spring pin. Then, using a brake spring compressor tool, push on the brake shoe hold down spring retainer and give it a twist to release it from the pin. Remove the shoe and repeat the process on the opposite shoe.
How do you adjust the brake shoe on a Jeep Cherokee?
Using a pair of needle nose pliers, lift up and remove your Jeep’s brake shoe adjuster lever spring. 7. Pull the adjuster lever downward and then unhook it from the adjuster lever pin attached to your Jeep’s brake shoe. 8. Unhook the brake shoe adjuster cable from the adjuster lever and set it aside. 9.
Using a pair of needle nose pliers, lift up and remove your Jeep’s brake shoe adjuster lever spring. 7. Pull the adjuster lever downward and then unhook it from the adjuster lever pin attached to your Jeep’s brake shoe. 8. Unhook the brake shoe adjuster cable from the adjuster lever and set it aside. 9.