Does a 1999 Jeep Cherokee have a distributor?
The ’99 will have a distributor. They went over to a coil rail waste spark system (not “coil on plug” as suggested above) for 2000 and 2001. The coil rail has three coils on it, each of which fires two cylinders at the same time, twice in each cycle.
Can a distributor cap cause a no start?
This is the best way to test the distributor cap. The distributor cap and rotor are infamous for causing no spark no start conditions. If you do get spark coming out of the ignition coil tower, you now know beyond a shadow of a doubt the distributor cap and rotor must be replaced.
How to replace ignition distributor in Jeep Grand Cherokee?
9. Rotor, cap, connections Now install the rotor, then the cap and distributor connector. Then using previously made notes correctly connect all ignition cables. 10. Fan Reinstall the auxiliary fan and connect negative battery cable. Start engine. Take a beer. Technorati Tags: Jeep, Cherokee, XJ, Grand Cherokee, ZJ, distributor, rotor, cap
Why does my Jeep Cherokee say no start?
The TPS is the throttle position sensor. IT sounds to me like the computer is not awake causing your no start condition. The first thing to do is to be sure the computer is awake. Turn the key on and check reference voltage to the tps, cam and crank sensors.
How does the distributor cap work on a Dodge Ram?
Voltage from the ignition coil is sent directly to the spinning rotor inside of the distributor, which then transfers the voltage to each contact point of the distributor cap. The electrical charge is then sent from the distributor cap to each of the engine’s spark plugs via spark plugs wires at the precise time for combustion to occur.
Why did my 1996 Jeep turn over but not start?
1996 Jeep turns over but will not start. I checked the spark plugs and there is no spark. Changed rotor, distributor Jeep Cherokee: 1996 Jeep turns over but will not start.
What causes a jeep to have a no start condition?
The usual suspects, that can cause this type of problem, are a bad fuel pump, bad crank sensor, bad ignition coil (if your Jeep is distributor equipped), etc. Does Not Crank Condition: Means that the engine is not cranking when you turn the key to crank the engine.
What happens when the distributor cap is not on?
Car doesn’t start. When the distributor cap isn’t on tightly or is malfunctioning, the engine is unable to send the spark through the entire circuit required to move the cylinders – which ultimately make the car run.
When to check your distributor rotor and cap?
Engine misfires can occur for a number of reasons. Checking your distributor rotor and cap to see if they need to be replaced is one way to ensure that everything is in solid working order. 2. Car doesn’t start