How to disable an airbag on a Jeep Grand Cherokee?

How to disable an airbag on a Jeep Grand Cherokee?

Disabling the airbag on a Jeep Grand Cherokee takes just a few minutes. The airbag that is attached to the steering wheel cover connects to the fuse box with a couple of electrical wires running through the steering wheel. You can access these wires from underneath the steering wheel when you remove the steering wheel column cover.

Is the Jeep airbag module reset by myairbags?

The best part of having your Jeep’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.

Where is the fuse on a Jeep Grand Cherokee airbag?

Find the airbag fuse by looking at the diagram on the fuse box lid to see which fuse operates the airbag. Remove the airbag fuse with a fuse puller and find the plastic steering column cover underneath the steering column. Unfasten the screws holding the steering column cover on with a screwdriver and set the cover out of the way.

Why does the airbag light stay on in a jeep?

If all parts of this system are not working properly, it can cause the airbag light to come on. If you’ve been in an accident, the airbag light is going to stay on until the system has been restored. It will not work until repaired. Here are some common reasons that your Grand Cherokee’s airbag light could come on. 1. Seat Belts

Disabling the airbag on a Jeep Grand Cherokee takes just a few minutes. The airbag that is attached to the steering wheel cover connects to the fuse box with a couple of electrical wires running through the steering wheel. You can access these wires from underneath the steering wheel when you remove the steering wheel column cover.

The best part of having your Jeep’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required.

Where are airbag codes stored in a jeep?

Below you will find common airbag codes that can be stored in your airbag control module after your vehicle was in an accident. The best part of having your Jeep’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play.

Find the airbag fuse by looking at the diagram on the fuse box lid to see which fuse operates the airbag. Remove the airbag fuse with a fuse puller and find the plastic steering column cover underneath the steering column. Unfasten the screws holding the steering column cover on with a screwdriver and set the cover out of the way.

If all parts of this system are not working properly, it can cause the airbag light to come on. If you’ve been in an accident, the airbag light is going to stay on until the system has been restored. It will not work until repaired. Here are some common reasons that your Grand Cherokee’s airbag light could come on. 1. Seat Belts

Is there a way to deactivate the passenger airbag?

But the passenger airbag can be deactivated if the car is equipped with a Passenger Airbag Cut Off Switch (PACOS). In most cases, to disable the airbag you need to have the ignition switched off to avoid any possible malfunctions. Source: YouTube. The PACOS is usually located in the passenger side of the dash board.

When to turn off or disable an airbag control module?

Tips for Disabling an Airbag Control Module. There are several circumstances in which you may need to turn off or disable your car’s airbag control module. You may need to replace the airbag if it is damaged in an accident or you may want to turn it off to put a child’s car seat in the front seat.

But the passenger airbag can be deactivated if the car is equipped with a Passenger Airbag Cut Off Switch (PACOS). In most cases, to disable the airbag you need to have the ignition switched off to avoid any possible malfunctions. Source: YouTube. The PACOS is usually located in the passenger side of the dash board.

When do all the warning lights come on in a jeep?

We have a 2007 Grand Cherokee that we picked up used. It has been working great for the past 8 weeks. Twice in the past week all the warning lights came on, the gauges went up and down, the engine did not loose any power. And the Check engine light stayed on.

When does the ABS light come on on a Jeep Grand Cherokee?

Your Jeep Grand Cherokee’s ABS Light comes on when it fails a self diagnostic cycle. When on, it indicates that the Grand Cherokee does not have Anti-Lock brakes, and the safety they provide. Your Grand Cherokee’s ABS system uses a system of sensors to determine wheel speed when braking.

What does the ESP Bas light mean on a Jeep Grand Cherokee?

The ESP BAS light is a trouble indicator light that indicates that there is an issue with your Jeep Grand Cherokee’s Electronic Stability Program (ESP) and/or your Brake Assist Program (BAS). These systems are important to the safety of your Grand Cherokee.

Where is the airbag light on a 1999 Jeep Grand Cherokee?

The airbag light illuminates on the instrument panel of your 1999 Jeep Grand Cherokee when there is a problem with the airbag system. Any problem with that system should be addressed immediately to prevent the airbag from malfunctioning. Once the problem has been fixed, the light may or may not still be on.

What does the diagnostic warning light on the Jeep Grand Cherokee mean?

Every time you start your Jeep Grand Cherokee, the computer system runs a self diagnostic check on all major systems. If any of these checks fail, you will see a diagnostic warning light on the dash for the corresponding system. When the airbag system fails this check, you’ll see the airbag light.

When do you see the airbag light on?

When the airbag system fails this check, you’ll see the airbag light. Depending on the model year and what country you happen to be in, you may get something along the lines of SRS, a picture of a person with the airbag deployed, or the word airbag. All of these should be treated as the airbag light.

Every time you start your Jeep Grand Cherokee, the computer system runs a self diagnostic check on all major systems. If any of these checks fail, you will see a diagnostic warning light on the dash for the corresponding system. When the airbag system fails this check, you’ll see the airbag light.

Why does the ESP Bas light come on on my Jeep Wrangler?

Steering Angle Sensor The steering angle sensor is one of, if not the most, common causes of the ESP BAS light to come on. As mentioned above, make sure to turn the steering wheel twice to the right, twice to the left, and finally back to the center. This resets the steering angle sensor in your Wrangler.

What are the warning lights on a jeep?

The following are warning lights and indicators found in vehicles built by Jeep. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray), but there are nearly 80 of them so be patient!

https://www.youtube.com/watch?v=YCKEqZDjwos

Is there a way to disable the passenger airbag?

You can disable the passenger airbags in your vehicle right from your home driveway, and it requires no special tools. Many vehicles come equipped with a key switch that allow you to disable the passenger’s airbag but not the driver’s side airbag.

When do you turn off the airbag in a car?

These cars disable the airbag automatically depending on conditions, for example when the passenger seat is empty. If you can’t deactivate the passenger airbag it is recommended that all children travel in the rear seats. Remember, DO NOT deactivate the front passenger airbag if you’re using a front facing child seat.

What happens if you put child seat in front of airbag?

There is a penalty for drivers who place a rearward-facing child car seat in the front where there is an active airbag. You may receive at least three penalty points on your driving licence if caught. Remember to re-activate the airbag whenever the seat is going to be occupied by a passenger.

These cars disable the airbag automatically depending on conditions, for example when the passenger seat is empty. If you can’t deactivate the passenger airbag it is recommended that all children travel in the rear seats. Remember, DO NOT deactivate the front passenger airbag if you’re using a front facing child seat.

There is a penalty for drivers who place a rearward-facing child car seat in the front where there is an active airbag. You may receive at least three penalty points on your driving licence if caught. Remember to re-activate the airbag whenever the seat is going to be occupied by a passenger.

Posted In Q&A