How do you take the front axle off a Jeep Cherokee?
Instructions
- Pull the Wheel and Tire off.
- Use a pair of Wire Cutters to pull the cotter pin for the axle nut.
- TIP – Sometimes the axle nut can be stubborn.
- Remove the brake caliper with a 13mm socket.
- Remove the brake rotor and use the 12 point ½” socket to remove the 3 bolts holding the unit bearing in place.
What axles are in a 2000 Jeep Cherokee?
Rear axle will be either the Chrysler 8.25, or a Dana 35 (if you have ABS it’s a D35). Transfer case will be either the NP231 or NP242.
How do you remove the rear axle from a jeep?
If you forgot your penetrating oil at home use anything handy like transmission fluid or brake fluid. Remove the shock bottoms with a ¾” socket. Remove the rear driveshaft end from the axle with an 8mm socket wrench and a screwdriver to hold the shaft from spinning.
How to identify the rear axle on a Jeep Grand Cherokee?
The video will show you where you need to look beneath the vehicle to find out which style of rear axle your Jeep Grand Cherokee has. You’ll be shown where to clean the dirt off of a specific area of the axle to obtain this important information.
Where are the shock absorbers located on a Jeep Cherokee?
Locate and remove the four retaining bolts where the front drive shaft meets the axle. Use a 10 mm wrench to loosen the bolts and slide the shaft out of the axle yoke, setting it out of the way. Locate the lower mounting bolts for the front shock absorbers on the axle near the base of the coil springs.
What’s the best way to remove an axle nut?
Use a pair of Wire Cutters to pull the cotter pin for the axle nut. Then remove the nut using a 36mm socket. Use a large screwdriver in your brake rotor to keep everything from spinning.
If you forgot your penetrating oil at home use anything handy like transmission fluid or brake fluid. Remove the shock bottoms with a ¾” socket. Remove the rear driveshaft end from the axle with an 8mm socket wrench and a screwdriver to hold the shaft from spinning.
What’s the front axle on a Jeep Cherokee?
OK, so what we’re after today is the front axle shaft. This is out of a ’95 Jeep Cherokee. The front axle shaft is what drives the front wheels when you’re in four wheel drive. It’s got a u-joint in it, and everything spins, so that you can get traction up front.
Locate and remove the four retaining bolts where the front drive shaft meets the axle. Use a 10 mm wrench to loosen the bolts and slide the shaft out of the axle yoke, setting it out of the way. Locate the lower mounting bolts for the front shock absorbers on the axle near the base of the coil springs.
Where can I get a new axle for my Jeep?
Replacement axles can be purchased new from a Jeep dealer, but buying a used axle from a salvage yard or auto parts recycling center can save you a large amount of money. Loosen the lug nuts on the front wheels of your Jeep with a lug wrench.