Where is the oil filter on a jeep?
As I said before, the old filter style has a seal on the inside to accept the top of the vehicle bypass valve assembly in the filter housing.
How to do an oil change on a 1999 Jeep Grand Cherokee?
It’s always a good idea to chock the wheels to be extra safe whenever working under your Jeep. Before starting to change the oil, run the engine for a few minutes to warm the engine oil. This will help the oil flow easier and quicker.
Where is the bypass valve on a jeep?
When you snap in the filter to the cap, the filter is lowered down over the bypass valve, it presses against the filter seal “O-ring”, and the bypass valve ‘nipple’ protrudes through the top of the filter and into the underside of the cap.
Where is the bypass valve on a new oil filter?
This new filter ‘poppet’ feature DOES NOT take the place of a properly functioning bypass valve inside the oil filter housing. It requires the nipple of the bypass valve to press on the underside of the filter poppet against the underside of the filter top.
Slide toward the front of the engine and locate the oil filter — the roughly 4-inch-long metal cylinder — on the driver’s side front of the engine. Position the drain pan beneath the oil filter and loosen the filter with an oil filter wrench. Allow the oil to drain from the filter until it stops flowing.
How do you change the oil in a Jeep Cherokee?
For most Jeeps, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Jeep Cherokee oil filter wrench. If your Cherokee is too low to the ground to access your drain plug and oil filter, be sure to use jack stands…
Where is the fuel filter located on a wrangler?
FUEL FILTER/FUEL PRESSURE REGULATOR Removal (Cherokee & Wrangler) 1. Fuel filter/fuel pressure regulator is mounted in gasket on top of fuel pump module. Fuel pump module is located on top of fuel tank. See Fig. 28 .
When to change transmission filter on Jeep Grand Cherokee?
Changing the transmission filter on your Jeep Grand Cherokee should be part of your annual car maintenance routine. A clogged or dirty transmission filter can reduce oil flow to your transmission, which can cause shifting and performance problems to your engine. Replacing your transmission filter is simple, quick and cost-effective.
How much does a Jeep Grand Cherokee oil filter cost?
Shop AutoZone for Jeep Grand Cherokee Oil Filter. 10% OFF $75. Use Code: DIYSAVE10 Online Ship-to-Home Orders Only
How to do an oil change on a jeep?
Pull the drain plug first, then go up top & do the filter. When you have the filter swapped most of the oil should be out. Sometimes I get the filter loose and let it sit to drain some oil from it before I lift it out. Have a rag ready. I like the socket. My wife’s BMW has basically the same system but doesn’t have a socket for the cap.
What kind of oil to change in a 4.7L Grand Cherokee?
Before starting to change the oil, run the engine for a few minutes to warm the engine oil. This will help the oil flow easier and quicker. According to the owner’s manual, 5W-30 is the preferred oil for both the 4.7L and the 4.7L High Output engines and is best for environmental operating temperatures below 100ºF.
Why does oil pressure drop on my Chreokee 4.0?
When it drops listen for unusual sounds coming from the engine, you can open you filler cap and check for oil sloshing around. As mentioned the location is near the oil filter and is usually soaked in oil which probably causes its malfunction. Hope you get it resolved soon.