Why does my blower motor not come on?

You should be able to find this relay or sequencer by tracing the blower motor wires back to the relay or sequencer. If power is going into the sequencer or relay and not coming out when the 24 volts are applied then you have a relay or sequencer problem and the sequencer or relay will need to be replaced to get your blower running right again.

Why is the resistor not working on my blower?

Hi There, The resistor is what controls the speed of the blower motor, not the relay. The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all.

How do you fix a blower motor on a car?

Disconnect the electrical connector at the blower motor and jumper power and ground to the motor, bypassing all the speeds controls. Run a fused jumper from the battery to the power side of the motor and connect a temporary grounding jumper to the other motor terminal.

How does the speed of a blower motor work?

This means that the current running through the blower motor, and its’ speed is therefore controlled by the resistor value. The user chooses a fan speed by selecting a speed which then connects one of the resistors in the blower resistor pack.

What causes a blower motor to stop working?

In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely. Blower motors generally don’t fail out of the clear blue.

How can I tell if my blower fan is a relay?

The only way to test and see if it is a blower motor relay would be to test with a voltmeter to see if the motor is getting 110 volts to the motor when it starts going off and on. I hope you can easily find and fix the problem.

How long does heat pump blower have to run?

Steve,, just had a new 3 ton Lennox heat pump and matching air handler installed couple of weeks ago. The blower is suppose to run , according to the manual, for 45 seconds after the thermostat is satisfied also shutting down the outside unit/compressor.

What causes an electric fan to slow down and stop?

The run capacitor stores charge and delays the current momentarily, which gives the fan rotor time to turn and orient itself so that the induced magnetic force is effective. When the capacitor burns out, the electric current through the coil is too steady to generate torque, and the fan slows down and stops.

What are the symptoms of a failed blower motor resistor?

Blower motor resistor problems. Problems with a blower motor resistor are common in many cars. The most common symptom of a failed blower motor resistor is when the heater fan only runs at high speed and doesn’t work at low speeds.

What does it mean if your blower motor is not working?

Average rating from 849 customers who received a AC is not working Inspection. The blower motor resistor is an electrical component that is a part of the vehicle’s heating and air conditioning system. It is responsible for controlling the blower motor’s fan speed.

How much does it cost to replace a blower motor resistor?

The blower motor resistor or control module replacement is not very expensive. For example, one of our colleagues had a problem with his 2011 Ford Escape: the fan only worked at the speed 4. He paid $50 to diagnose and $112 to replace the resistor at a local Ford dealership.

Why is the blower motor on my Nissan Altima not working?

Unfortunately the blower motor on the Altima is not working. The Blower motor LED lights light up to high speed but no fan. I am no where near the car ( My wife has it far away ) but I’m wondering if it is a fuse or the motor?

Is the blower motor the same as the fan control AMP?

Our version (at least for the auto control AC) is the Y33. The metal housing looks different, but the circuit board is the same with the same value components. In short, the blower motor is mounted in series with the fan control amp. The auto AC regulates the fan control amp, which regulates the voltage to the blower motor.

Why is the blower on my Nissan club not working?

Checked the two fuses, and they are both good. I can hear the AC compressor kick on if I lower the temp, but no air flow coming from the vents. Switching from defrost, floor, dash vents and no air flow. Manually adjusting the fan speed and still no air flow. It looks like there is a resistor plug that inserts into the blower assembly.

What should I do if my blower motor is not working?

If it’s good, refer to a wiring diagram for your vehicle and conduct these tests: Disconnect the electrical connector at the blower motor and jumper power and ground to the motor, bypassing all the speeds controls.

How does a blower motor work in a car?

Carmakers use these three common wiring methods to supply power and ground to the blower motor in a manual system using a blower motor resistor. In one design, the car maker supplies battery power to the speed switch, which switches the power to the appropriate connection on the blower motor resistor.

Why is the blower motor on my Durango not working?

Key on, blower switch off, verify for 12V at motor connector, on BOTH wires. If NO then it’s the ignition switch……….. In addition to the resistor causing this issue, so can the connector that plugs into it. Two weeks ago I had to replace that connector on my wife’s Durango.

What causes a bad or failing blower motor relay?

Blown fuses. One of the first symptoms of a bad or failing AC blower motor relay is a blown AC blower motor relay circuit fuse. If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current…

What happens if you lose the blower motor relay?

The blower motor is the component responsible for pushing air through the vents of your vehicle’s heating and air conditioning systems. Without it, the AC system will not be able to circulate any heated or cooled air. The blower motor relay controls the current used to power the blower motor,…

What can cause 2007 Kia Spectra blower motor to stop blowing?

What can cause a replaced 2007 Kia Spectra blower motor to stop blowing? First, check the blower motor for power using a test light, as it can likely cause this problem to occur. To do so, put one lead of the tester at the connector’s red/black stripe wire and the other to a clean metal piece to get a proper ground.

How can I tell if my AC blower motor is broken?

Air Conditioner Blower Motor Won’t Turn On. If you turn on your air conditioning system and find that there is no air blowing out of the AC unit, or no buzz of the blower fan motor, then it is possible the AC blower motor has an issue. This is one of the most common and easy ways to know if your air conditioner blower motor is broken or not.

What to do if your blower motor wont start?

You can test by testing with a voltmeter set to “Volt AC” between the high-speed blower wire (usually black) and the white neutral wire. If you are getting 120 volts to the motor and it is not starting then you have a blower motor problem and either need another new blower motor or a new blower motor run capacitor.

Why does my AC fan stop blowing cold air?

Because the fan motor is one of the hardest working parts on an air conditioner, it is subjected to a lot of wear and tear that can lead to frequent repairs or replacement. Once the fan motor breaks down, the AC will stop blowing cold air and that’s something you don’t want on a hot summer’s day.

When do you Know Your AC fan motor is bad?

If the compressor is working but the fan blades are not spinning, the motor is faulty. That’s your cue to turn the system off and call the pros to repair the AC fan motor. Replacing an HVAC motor is a job that can be done quickly once the problem is identified.

What to do if your AC blower is not working?

Disconnect cables to motor and resistor. Remove hose from motor, it should just pull off with little effort. Unscrew motor and resistor. Screw new motor and resistor in. Connect hose to motor. Connect cables to motor and resistor. Turn on car and test AC. Thanks for watching! Loading…

Why does my air conditioner fan not come on?

Top 10 Reasons Why the Blower Fan Motor will not come on. Furnaces, Air Conditioning and Heat Pumps • Arnold’s Service Company, Inc. Top 10 Reasons Why the Blower Fan Motor will not come on. Furnaces, Air Conditioning and Heat Pumps

When do you need to replace the blower motor relay?

If the blower motor does not function, car fuses are blown, or relays are melting, you may have to replace the car blower motor relay. 1. Blower motor does not function 2. Blown fuses 3. Melted relay The blower motor relay is the electrical switch that is used to supply the power for the vehicle’s blower motor.

How is the speed of the blower motor controlled?

The electronic module that controls the speed of the blower motor is called a blower motor control module. In some cars, the blower motor has only 4 or 5 fixed speeds. In this case, the speed of the blower motor is controlled by a blower motor resistor.

Why does my furnace blower not come on?

I have an older Maytag furnace that will fire up but the blower motor doesn’t come on, after a minute the the limit switches will turn of the furnace because it will get to hot. I already replaced the motor, the limit switches, and the motor board but I still have the same problem.

Why does my Mercedes-Benz A / C blower run uncontrolled?

But under fault conditions it could fail as ‘always on’ or ‘never on’. Mostly (according to this forum) a failed BR causes the a/c blower to run uncontrolled. Btw your WIS a/c circuit diagram is not identical to mine for W208. However the blower motor/regulator part is the same.

What causes a fuse to blow on a blower motor?

If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.

What are the symptoms of a bad heater motor resistor?

Symptoms of a Bad or Failing Heater Blower Motor Resistor. 1 1. Blower motor stuck on one speed. A common symptom of a faulty blower motor resistor is a blower motor that is stuck on one setting. The blower 2 2. Blower motor does not work on certain settings. 3 3. No air from the vehicle’s vents.

Why is my AC blower not working?

A common problem behind an air conditioner blower not starting includes overheating, which keeps the motor from running. Let your air conditioner rest and cool down for a while before trying to turn it on again; if the motor works at that point, overheating is probably the problem.

What are the symptoms of blower motor failure?

Lack of air from the vehicle’s vents
Stuck on specific settings
Stuck at one speed

Is my blower motor bad?

No air from the vents. No air flow from the vents when the heater or air conditioning is activated is another symptom of a bad blower motor. If the heater blower motor burns out or short circuits, it will not function, and therefore will not be able to produce any airflow for the system. The blower motor will usually have to be replaced in order…

Why does blower motor resistor keep going out?

The blower motor appears to be defective here. When the brushes wear out the motor draws excessive amps which could cause the resistor to burn out. Before making further replacements remove the motor and check it, especially the brush assembly. This is the most likely reason for the resistor to fail repetitively.

How many volts does a blower fan need?

You should be getting 120 volts out of the control board. You can test by testing with a voltmeter set to “Volt AC” between the high-speed blower wire (usually black) and the white neutral wire.

Steve,, just had a new 3 ton Lennox heat pump and matching air handler installed couple of weeks ago. The blower is suppose to run , according to the manual, for 45 seconds after the thermostat is satisfied also shutting down the outside unit/compressor.

Navigation