How do I get my jeep key out of the ignition?
Wiggle the Steering Wheel Give the wheel a wiggle while lightly trying to turn the key out of the ignition. If the steering lock is causing a bind, this will relieve the pressure and get the key out.
Where is the ignition switch on a Jeep Grand Cherokee?
Insert the ignition key into the key cylinder. Rotate the slot in the ignition switch to the “ON” position. The slot is located on the back of the ignition switch. Position the slot so it is just beyond a 90-degree angle. Attach the two electrical connections to the back of the ignition switch.
How do you remove an ignition lock cylinder?
Step 8: Loosen the screws on top of the ignition lock assembly. The lock cylinder is secured to the lock assembly by a button on the bottom of the housing and two screws on top of the lock assembly. Loosen the two screws on top to allow you to remove the cylinder.
What happens when the lock cylinder is broken on a jeep?
Once depressed, the lock cylinder will slide out of the switch. If the lock cylinder is broken (as illustrated) make sure you locate and remove the broken piece from inside the switch to avoid an electrical short.
What are the symptoms of a broken ignition lock?
Some of the common symptoms of a damaged or broken ignition lock cylinder include the vehicle not starting or power not supplied to the vehicle when the ignition is turned. Most modern cars that have keyless remote starting have a key that has a computer chip inside of it.
Insert the ignition key into the key cylinder. Rotate the slot in the ignition switch to the “ON” position. The slot is located on the back of the ignition switch. Position the slot so it is just beyond a 90-degree angle. Attach the two electrical connections to the back of the ignition switch.
How to replace ignition distributor in Jeep 4.0L engine?
Now lie under the car and turning the crankshaft vibration dumper clockwise (!) find the notch on it and mark it with sharpie – it will make our job a little easier: Then, this time from the top, rotate it clockwise until that notch will be aligned with 0 degree mark: Now the rotor should be aligned with the mark we did before:
How do you install a replacement ignition switch?
Position your replacement ignition switch at the edge of your steering column so it is prepared to install. Change the switch’s slider so that it is set on “Accessory.”. Attach the slider hole and actuating rod. Connect the switch.
Can you turn the crankshaft vibration damper on a Grand Cherokee?
This step is only necessary when procedure is done on the Cherokee (XJ) model – this is the only way to turn the crankshaft vibration damper. In Grand Cherokee (ZJ) you have access to this bolt from underneath. Now disconnect the battery negative cable, then disconnect the radiator fan electric connector: