Can my car antenna go through a carwash?
Car Antennas: Most antennas can either be unscrewed or pushed down so they no longer protrude from the car’s exterior. They’re flexible enough to withstand the occasional automatic car wash, but it’s best if you get in the habit of removing these items before you head in.
How do you change the antenna on a jeep?
Tighten the antenna adaptor to the bottom of the quick release using 16mm and 13mm wrenches. Put the PVC bezel over the factory antenna base, and thread the antenna adaptor and quick release into the factory base by hand.
How do you remove power antenna from car?
Unscrew the bezel (Photo 1) and remove the antenna retaining bolts. If your power antenna is mounted inside the front fender, remove the wheel-well liner by pulling out the plastic rivets and push-in retainers. Next disconnect the power and coaxial cable connectors and remove the entire unit from the vehicle (Photo 2).
How do you attach an antenna to a base?
Put the PVC bezel over the factory antenna base, and thread the antenna adaptor and quick release into the factory base by hand. Use the 16mm wrench again to tighten the adaptor to the factory base until it fits snugly.
How do you remove a factory antenna mast?
Start by removing your factory antenna mast with the 10mm wrench. Tighten the antenna adaptor to the bottom of the quick release using 16mm and 13mm wrenches. Put the PVC bezel over the factory antenna base, and thread the antenna adaptor and quick release into the factory base by hand.
Tighten the antenna adaptor to the bottom of the quick release using 16mm and 13mm wrenches. Put the PVC bezel over the factory antenna base, and thread the antenna adaptor and quick release into the factory base by hand.
Put the PVC bezel over the factory antenna base, and thread the antenna adaptor and quick release into the factory base by hand. Use the 16mm wrench again to tighten the adaptor to the factory base until it fits snugly.
Start by removing your factory antenna mast with the 10mm wrench. Tighten the antenna adaptor to the bottom of the quick release using 16mm and 13mm wrenches. Put the PVC bezel over the factory antenna base, and thread the antenna adaptor and quick release into the factory base by hand.
What kind of wrench do you use to remove an antenna?
There are only four components we’re working with: the antenna mast, the antenna adaptor, the machined PVC bezel, and the quick release assembly (optional). Start by removing your factory antenna mast with the 10mm wrench. Tighten the antenna adaptor to the bottom of the quick release using 16mm and 13mm wrenches.