Do you need to change the oil plug?
You definitely do NOT need anew drain plug at every oil change. Depending on the vehicle , you MAY need a new crush washer at every change ( gasket). If you have been told that you need to replace both at every change by a dealer, quick change place or other, you have been being ripped off.
Where does the oil come from on a spark plug?
If your spark plugs look like the picture above, fully covered with oil when you remove them, you can feel lucky. When the oil on your spark plug looks like this, it is not coming from the engine’s inside; it is actually coming from the outside.
How do you change the oil in a Honda Civic?
Slide the oil drain pan beneath the drain plug so that it catches the oil when you start to drain it. Use a 17 mm box-end or socket wrench to loosen the drain plug. When you’re able to, remove the wrench and loosen it by hand. Be sure to wear protective gloves (and eyewear).
Why do I need to change my spark plugs so often?
If you know your vehicle is leaking oil onto the spark plugs, you will need to change them more often. As oil leaks onto the spark plugs, they will corrode faster, and there will be a greater change that carbon buildup will result from unburned fuel. O-ring seal replacements will usually fix this issue, but not always.
How often should I change the oil in my Mini Cooper?
Modern cars and trucks need much less maintenance than the vehicles of 25 years ago, but they still have needs. You no longer necessarily have to do a tune-up every 6 months, or change the oil every 3 months, but regular fluid changes are still essential to your vehicle’s longevity.
What do I need for a lower unit oil change?
While it isn’t too difficult to handle your own lower unit oil change, you do need to have the right equipment on hand. At a minimum, you’ll need: ● Replacement sealing washers and O-rings for vent plug and drain screws To help clean up any potential spills, you should also keep several clean rags nearby.
How do you change the oil in a Harley Davidson?
Drain the engine oil into an oil pan. Replace the drain plug’s O-ring, then screw it into place after the oil has drained. Tighten the drain plug to 18 foot-pounds with a torque wrench. Unscrew the oil filter from the front of the engine, using an oil filter wrench. Drain any oil trapped within the filter housing into your oil pan.
What kind of oil do you put in a motorcycle drain plug?
Reinstall the primary drain plug. Make sure it is snugged well, but do not over-tighten. Use a long-tipped and narrow funnel to get the oil down into primary through the derby cover or inspection cover. You should only need 32-38oz to sufficiently fill the primary, and any motorcycle specific oil will do.
What kind of wrench do I need to change oil?
Place a 3/8-inch (0.9 centimeters) socket in the socket wrench, fit it over the drain plug’s nut and turn it counterclockwise. The oil drain plug should open easily, draining the used oil from the engine.