How do you remove a sway bar link?
Depending on the make and model of your car, you may have only front sway bars links, or front and rear sway bar links. Step 7: Remove the lug nuts. Two lug nuts hold the sway bar link in place. Start by removing the upper nut first. This nut holds the most weight when the sway bar is at normal rest, so it tends to be the most problematic.
Can you remove the nut from a sway bar?
Remove the nut holding the sway bar link to the sway bar. You will have to grip the shaft below the sway bar so it does not turn – for example pair of vice grip locking pliers.The bottom bolt you can use a socket wrench on the nut, and a wrench on the nut on the other side of the mounting point (see picture). Install the new link.
Where are the sway bars on a car?
Sway bars are usually located at the front of the car and are bolted to the suspension on your vehicle. Depending on the make and model of your car, you may have only front sway bars links, or front and rear sway bar links.
What’s the best way to change a sway bar?
When tightening the nuts, again you will need to use a socket wrench on the bottom on the larger nut, regular wrench on the smaller nut. Be sure to use the correct sizes so they do not strip/become damaged. On the top, a socket wrench and vice grips so the shaft does not spin. Compress the bushings about half.
When to replace sway bar links-testing autos?
An extremely worn out sway bar link can separate. This will cause your car to lean excessively in turns and feel less stable and secure on the road. A worn out sway bar link must be replaced to keep your vehicle safe. In a pickup truck, sway bar links have a slightly different design, see the lower photo.
What’s the best way to replace a sway bar?
Use an open-end wrench, Torx-head screwdriver, or an Allen-head screwdriver (depending on the vehicle design) to hold the stud portion of the sway bar link. While holding the stud, loosen and remove the retaining nut using another wrench or a ratchet and socket.
Is it possible to change more than one sway bar link?
If you are changing more than one sway bar link, simply repeat the steps on the other side. Replacing the sway bar links is a repair process that can be done with a few basic tools. If you don’t have access to the correct tools or are short on time, ask a certified mechanic from YourMechanic to replace the sway bar links for you.
How do you replace a sway bar link?
Step 1: Engage the parking brake. Step 2: Loosen the lug nuts. Step 3: Raise your vehicle. Step 4. Secure the vehicle. Step 5: Remove the tire. Step 6: Locate the sway bar link to be replaced. Step 7: Remove the lug nuts. Step 8: Apply pressure on the sway bar. Step 9: Make sure the new sway bar link matches the old one.
Do I need to change my sway bar links?
There is no need to replace a sway bar link if it’s working properly and is not worn out. Replacing a sway bar link is not very expensive. Typically, it costs $75-$140 per side in a repair shop.
How much does it cost to replace a sway bar?
Sway Bar Replacement Cost. Typical cost to change the front sway bar bushings and links range between $450 and $900 depending on make and model. The good news is that the parts themselves are very cheap, especially if you buy them online. The typical cost of front sway bar links and bushings is under $100.
What are the symptoms of a bad sway bar?
Symptoms of Sway Bar Problems. Some of the common symptoms of a bad sway bar bushing or sway bar links going bad are: clunking noise, rattling noise, knocking uneven noise road, lack of stability when driving and noise going over speed bumps. poor handling during turns.