What is ASL on Jaguar XF?
The Automatic Speed Limiter (ASL) feature is a driving aid only. The driver remains responsible for driving with due care and attention, in a manner which is safe for the vehicle, its occupants and other road users. Driver intervention may be required as engine braking is unable to maintain or reduce the vehicle speed.
How do I turn off ASL on my Jaguar XF?
To lower the ASL set speed, press and hold the – button on the steering wheel. A single press of the – button lowers the set speed by 2 km/h (1 mph). To suspend ASL operation, press the CAN button on the steering wheel. To resume ASL operation, press the RES button or the SET+ button on the steering wheel.
Why does my Jaguar XF not start up?
On doing so, the vents opened, the radio came on but the gear selector did not rise from the centre console and the dash showed a battery sign. The car also made a click noise (single ‘ting’).
When to reset the clock on a Jaguar?
Refer to the audio systems handbook or touch-screen display handbook. • If the battery is disconnected for more than 72 hours the radio preset channels will need to be reset. • Reset the clock to the correct time.
How to reset the ecu-1 Jaguar car forum?
Restart the clock (where fitted) and set it to the correct time. Simultaneously press “>>” “PTY” “A.MEM” should only take 2 or 3 seconds and the radio turns on. 1. NOTE: After the battery has been disconnected it is necessary to
What should I do if my DSC is not installed?
If you are facing the below error, ensure that the DSC is installed or token is plugged in your system. Click the OK button and install the DSC or plug the token in your system. Or if the DSC is still plugged in and you are facing the above issue, please follow the below mentioned steps:
Can a DSC system fault be found on a Jaguar?
Chelmsford Carriage Company stuck her on diagnostic but typically the light stayed resolutely off and no fault was found. They’ve referred me to an auto electrical specialist but before I part with yet more of my hard-earned I wondered if anyone here had similar experience and/or ideas?
Why does my car say DSC system fault?
AIUI, when you turn the car on it runs through its power on diagnostics and if it determines there’s not sufficient charge in the battery to check the ABS/DSC is pops up the message rather than risk leaving you with inadequate voltage to start the engine, hence people’s confusion when they say “the car starts perfectly so the battery must be okay”.
Refer to the audio systems handbook or touch-screen display handbook. • If the battery is disconnected for more than 72 hours the radio preset channels will need to be reset. • Reset the clock to the correct time.
Restart the clock (where fitted) and set it to the correct time. Simultaneously press “>>” “PTY” “A.MEM” should only take 2 or 3 seconds and the radio turns on. 1. NOTE: After the battery has been disconnected it is necessary to