Why does my cruise control cut off when I step on the pedal?
If the switch has any sort of contact or internal issues, it may cause the cruise control system to cut off unexpectedly when activated, even if the pedal is not stepped on.
Why does my cruise control stay on even when the brakes are applied?
Cruise control stays on even when the brakes are applied. Another common symptom of a potential problem with the cruise control brake release switch is a cruise control system that stays on even when the brakes are applied.
What should you do when cruise control is set?
This will likely entail simply pressing another button on the steering wheel. After the cruise control is set, you may remove your foot from the accelerator. The car should maintain its speed. When driving a vehicle that is being accelerated by a cruise control system, it is important to watch the road carefully.
Where is the cruise control button on the steering wheel?
Once you reach your desired speed, turn the cruise control system on. In most vehicles, the buttons that control the cruise control system appears on the steering wheel. You should check your owner’s manual and locate these buttons when the car is not being driven to avoid an accident.
What kind of ECM does XJS cruise control use?
USED CRUISE CONTROL MODULE ECM FITS 1992-1996 XJS. NLA (DBC5608) BUSHING FOR SPEED CONTROL ACTUATOR FITS XJS 5.3 AND 6.0 FROM 1992-1996. This is the small plastic bushing that supports the rod connecting the cruise control actuator to the throttle pedestal.
When did XJS speed control actuator go bad?
BUSHING FOR SPEED CONTROL ACTUATOR FITS XJS 5.3 AND 6.0 FROM 1992-1996. This is the small plastic bushing that supports the rod connecting the cruise control actuator to the throttle pedestal. This goes bad due to typical underhood heat, and when it does, the throttle can stick open. Very bad!
Where is the cruise control switch on a Jaguar XJ6?
NLA MICROSWITCH FOR SPEED CONTROL LOCATED UNDER THE CENTER CONSOLE ON GEARSHIFT HOUSING FITS 1980-1987 XJ6 AND 1981-1987 XJS WITH CRUISE CONTROL (DAC2165) USED INHIBIT MICROSWITCH FOR SPEED CONTROL LOCATED UNDER THE CENTER CONSOLE ON GEARSHIFT HOUSING FITS 1980-1987 XJ6 AND 1981-1987 XJS WITH CRUISE CONTROL (DAC2165) CRUISE CONTROL MASTER SWITCH.
What causes the cruise control to stop working?
Most common cause of erratic cruise control? Vacuum leaks caused by deteriorated hoses. Cruise control on your vehicle is a terrific device. It substantially reduces the driver’s workload on longer trips, and can save substantial amounts of fuel and expense over the life of the vehicle–until it stops working.