Do automatic transmissions have a ring gear?
There are many different parts in an automatic transmission including bands, clutches, a hydraulic system, and a gear pump, but it all starts with the planetary gear set. So, from inside out, it’s the sun gear, then planet gears, and then the ring gear.
What are the gear ratios for a Turbo 350 transmission?
The gear ratios used for this transmission were 2.52 for 1st gear, 1.52 for 2nd gear, and 1.0 for 3rd gear. The Turbo 350 transmission was a single piece transmission with the bell housing integrated into the transmission body. The transmission casing is made of cast aluminum.
Where is the passing gear linkage on a 350C?
Sit down and carefully slide backward until you reach the side of the transmission facing the driver door. This is the side opposite the transmission coolant lines. Locate the bell housing on the 350C Turbo transmission. Directly behind the bell housing, on the driver’s side, is the passing gear linkage.
How can I tell if my car has a Turbo 350 transmission?
If the Turbo 350C transmission is not in a vehicle, you can identify it by examining the input shaft. Turbo 350Cs have a hollow input shaft where the torque converter slips on. An “O” ring will be in a grove 1/4 of an inch back from the front of the shaft. Earlier model Turbo 350 transmissions had a solid input shaft.
What kind of transmission does a GM 350 have?
The Turbo-Hydramatic 350, commonly referred to simply as the “Turbo,” was a three-speed automatic transmission first produced by General Motors in 1969. The Turbo 350 was known as a durable transmission and was used extensively by GM.
How many teeth would be on drive gear for a 1981 Turbo 350 transmission?
How many teeth would be on a drive gear for a 1981 Turbo 350 transmission?, i need to change my Speedo gear since the rear end has been changed to 3.73 and need to find out how many teeth the drive gear has in order to do the calculation I’ll explain the process one more time.
Where can I find the drive gears for my 350?
Then you need a calculator that will tell you the ratio of the speedometer gears so you can select the drive and driven gears for the transmission speedometer gears. The best one I’ve found is the one at Bowtie Overdrives: http://www.700r4.com/speedoCalc/speedocalc.shtml
Is the Turbo 350 transmission rear wheel drive?
The most torque from an engine that this transmission was applied to was 410 lb-ft. This is an automatic transmission that is longitudinally mounted, making it applicable for rear-wheel drive cars. This transmission is a 3 speed, and no overdrive gear was available.
What kind of transmission does a GM TH350 have?
Turbo 350 Transmission Specs. This transmission replaced the GM Powerglide automatic transmission, which was a 2 speed automatic transmission that was in production for 23 years. The Turbo 350, known by the name TH350, was used in nearly all GM rear wheel drive car and truck applications during its tenure.