When does the transmission slip on a Chevy Impala?
Transmission slips when you stop at light when you step on accelerator to go transmission slips and then suddenly catches and car jerks quickly forward causing car suddenly lunge forward. See all problems of the 2007 Chevrolet Impala . Airbag light goes on and off while driving.
Are there any problems with the Chevy Impala?
Chevrolet Impala owners have reported 43 problems related to transmission gear slipping (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chevrolet Impala based on all problems reported for the Impala.
Why does my Chevy Impala stall at 35 mph?
Every time I am accelerating out of first gear to second gear, around 35 miles per hour, my car shudders as if to stall then it makes clicking sounds and my RPMS fly up the scale. The car remains at 35 MPH until I let off of the accelerator.
What should I do if my transmission is slipping?
After adding the fluid, I suggest that while the car is running, you move the shift lever through the different gears on the shifter selector, and then check the fluid again. Running the shifter through the gears redirects the fluid to different parts of the transmission and removes the air pockets.
Why is the transmission slipping on my Chevy Impala?
Took to dealer said it is a $700 repair for the “seat belt tensioner”. Transmission exploded at 30,000 miles. At 60,000 mile had to replace transmission again. Now at 108,000 miles transmission is now slipping and not accelerating properly from a stop. From starting position to slowing driving the transmission slips and or jerks into gear heavily.
Chevrolet Impala owners have reported 43 problems related to transmission gear slipping (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Chevrolet Impala based on all problems reported for the Impala.
What to do if your transmission is slipping?
Hope this helps! Pressure control solenoids are a common failure, slip/bang is a common failure mode before they set codes, codes like P1811, and P0961 if it detects an electrical issue. It can be replaced with transmission in situ, but does require removing side cover and lowering the drivers side of the subframe several inches.
Why does my transmission slip when I put the car in neutral?
From a stopped position, trying to take off car acts as if I’m neutral and then will suddenly jerk into gear. The automatic hear shifts are rough and delayed. There’s very little power or struggle to register when applying gas.