When should a shifter cable be replaced?
5000 to 6000 miles is a good time frame to replace the cables. Other wise wait till they brake and either have a good stiff pedal in or nice easy spin, depending on the broken cable.
How much does it cost to replace a shift cable?
A factory part costs about $185, and an ATP cable costs about $48. The total cost to complete the shift cable replacement would be about $425 using OE parts, or about $268 using aftermarket parts. The problems that occur with shift cables are about the same whether they are used on automatic or manual transmissions.
Can a failed Trans shift cable be repaired?
Vehicles will a failed or failing automatic transmission shift cable should be repaired right away. While the vehicle can operate if it moves into gear, the chances of breaking the shift cable is high, and this will leave you stranded.
Where does the shift cable go on a truck?
On an automatic transmission car or truck, the shift cable connects from the driver’s shift lever to the shift lever on the transmission. If the driver’s shift lever is on the steering column then the cable runs from there, under the dash, and through a grommet on the firewall, then to the transmission.
What happens if the shift cable breaks between gears?
While the vehicle can operate if it moves into gear, the chances of breaking the shift cable is high, and this will leave you stranded. In cases where the transmission shift cable breaks between gears, it is likely the transmission will be locked into park, reverse, or neutral, even though the gear selector reads drive or a lower range.
What does the shifter cable do?
A transmission shift cable (also called a shifter cable or any of the names listed above and even others that we may not have yet heard), is the link between the shifter handle and the transmission in a vehicle . Its position changes as a driver moves the shifter handle the vehicle choosing the gear setting of a vehicle.
What is a shift cable?
The shift cable is a two piece shift cable. The front half (column end) or rear half (transmission end) of the shift cable can be removed without removing the other end/half of the shift cable.
What is gear shift cable?
The shift selector cable connects the gear shifter, located on the steering column or on a floor mounted console, to the automatic transmission. The cable is typically steel and is protected from the elements by a plastic outer sheath. At each end of the shift cable, often rubber or nylon bushings allow for cable movement and vibration.
What is a cable shifter?
The shifter incorporates two cables, one that operates the brake and one that controls the derailleur. The derailleur is the mechanism that moves the chain to a given sprocket. The derailleur cable is also known as a shifter cable. Generally, shifter cables are replaced as part of a yearly tune-up or if the cable is frayed or damaged at any point.