How do you reset the EPB on a Jaguar?
This indicates that the parking brake is in calibration mode. 5. Lightly press the footbrake pedal. 6. Apply the parking brake by using the EPB switch. 7. Release the parking brake. 8. Release the footbrake.
How to reset the electronic parking brake on a 2009 XF?
Disconnect battery for approximately 30 seconds. Connect battery. Start engine. Firmly depress and release brake pedal 5 times. The message “APPLY FOOT AND PARK BRAKE” or “NOT CALIBRATED” will be displayed in the multifunction display. Lightly depress brake pedal and hold in position. Pull EPB switch to apply parking brake.
How to reset the parking brake on a Jaguar?
Workshop Manual, section 414-01). c. Re-connect the battery. 2. Start the engine. 3. Firmly apply and release the footbrake five times. 4. Confirm that the message ‘NOT CALIBRATED’ or ‘APPLY FOOT message center. This indicates that the parking brake is in
Where is the parking brake actuator on a Jaguar XF?
Here is a link to the workshop manual for the 2010 XF. As far as I know, this will be exactly the same braking system as the OP’s 2008, 2.7d. The removal procedure for the parking brake actuator starts at page 717. By the looks of it, once you’ve dropped the diff’, the actuator becomes readily accessible.
Disconnect battery for approximately 30 seconds. Connect battery. Start engine. Firmly depress and release brake pedal 5 times. The message “APPLY FOOT AND PARK BRAKE” or “NOT CALIBRATED” will be displayed in the multifunction display. Lightly depress brake pedal and hold in position. Pull EPB switch to apply parking brake.
Workshop Manual, section 414-01). c. Re-connect the battery. 2. Start the engine. 3. Firmly apply and release the footbrake five times. 4. Confirm that the message ‘NOT CALIBRATED’ or ‘APPLY FOOT message center. This indicates that the parking brake is in
This indicates that the parking brake is in calibration mode. 5. Lightly press the footbrake pedal. 6. Apply the parking brake by using the EPB switch. 7. Release the parking brake. 8. Release the footbrake.
How can I Reset my parking brake motor?
Resetting NOTE: Resetting can also be carried out using diagnostic equipment. Ensure ignition switched OFF. Disconnect battery for approximately 30 seconds. Connect battery. Start engine. Firmly depress and release brake pedal 5 times. The message “APPLY FOOT AND PARK BRAKE” or “NOT CALIBRATED” will be displayed in the multifunction display.