Why is my 2002 jaguar x type overheating?
While there are a variety of reasons your Jaguar X-Type is overheating, the most common 3 are a coolant leak (water pump, radiator, hose etc.), the radiator fan, or a failed thermostat.
What kind of electrical system does a Jaguar X-type have?
The Jaguar X-TYPE electrical system is a supply-side switched system. The ignition switch directly carries much of the ignition switched power supply load. Power supply is provided via three methods: direct battery power supply, ignition switched power supply, and “Battery Saver” power supply.
What should the coolant temp be in a Jaguar?
Do not start the engine. Pull the connector from the CTS. Touch one probe of the meter to one pin on the CTS. Touch the other probe of the meter to the other pin. The resistance values at various engine temperatures shown below should be within 10%. 0 degrees C (32F) 5.9 kohms
What are the abbreviations for Jaguar X-type?
Abbreviations and Acronyms Jaguar X-TYPE 2.0L/2.5L/3.0L The following abbreviations and acronyms are used throughout this Electrical Guide:
Why is the coolant sensor on my Jaguar not working?
The CTS pin contacts, and the wiring harness contacts are also prone to failure due to corrosion. Failure of any of these items, will cause a no start, a hard start, or if the engine starts, poor idle, or overfueling, and a possible shut down of the engine shortly thereafter.
How to reset the ecu-1 Jaguar car forum?
Restart the clock (where fitted) and set it to the correct time. Simultaneously press “>>” “PTY” “A.MEM” should only take 2 or 3 seconds and the radio turns on. 1. NOTE: After the battery has been disconnected it is necessary to
When to reset the clock on a Jaguar?
Refer to the audio systems handbook or touch-screen display handbook. • If the battery is disconnected for more than 72 hours the radio preset channels will need to be reset. • Reset the clock to the correct time.
How to reset the battery in a Jaguar?
8 Release the foot brake. 9 Confirm that the brake warning lamp is no longer illuminated on the instrument pack and that “NOT CALIBRATED” message is no longer displayed in the message centre. 10 apply and release the EPB 5 times to ensure no error is present.