How to check service engine light on 2006 Chevy?
An OBD scanner tool can be used to read the codes and tell you exactly what is wrong with the vehicle. You can purchase an OBD scanner and do this yourself at home or you can take your car to your local auto parts retailer and they will scan and diagnose it for you for free.
What causes a flashing check engine light on a Chevy Silverado?
While a majority of the time, the flashing check engine light is going to be caused by a misfire related to your Silverado’s ignition system or fuel system (as stated above), there are other issues that can cause it. Your timing chain could have jumped .
What should I do if my check engine light is still coming on?
Put the keys in your ignition and turn your ignition on and off consecutively after a second in each step. Once it is done, see if the engine check light is still coming on or not. If the check light is off, you are ready to go, but if it is still coming on, get ready by reading the codes with a scanner instead. Let it Go Off Itself
Why does my check engine light keep blinking?
When your engine is misfiring, it is dumping raw fuel into the exhaust. This raw fuel can detonate, which causes damage to the catalytic converter and the exhaust system itself. There can be other situations that can cause the check engine light to blink as well.
Why does my check engine light keep turning on?
On average, a quality O2 sensor will set you back about $175, but the cost of labor will vary greatly depending on the vehicle’s make and model, as well as your geographical location. Finally, keep in mind that most late-model cars have more than one O2 sensor. A loose fuel cap is one of the most common reasons why the check engine light turns on.
How to reset the ” Check Engine ” light?
4 Ways to Reset the “Check Engine” Light Method Tools Required 1. Drive your car and let light go off b None 2. Turn the engine on and off three time None 3. Disconnect and reconnect the battery. Wrench 4. Use an OBD code reader. Wrench and OBD reader
Where to plug in the Check Engine light?
Plug the reader into the OBD port of your vehicle. This port is usually located on the underside of the dash area just above the foot well. On some vehicles, you’ll have to remove the door on your fuse box to access this port. Once you have connected the reader, press the “enter” button to turn it on.
Is the tighten gas cap light still on?
The light still remains lit but the message “Tighten Gas Cap” does not come on anymore. If it bad that I am still driving on this code & engine light? Could I fix this problem myself rather than taking it to a stealership?