What does it mean when a blower motor resistor fails?
In our case the ohmmeter shows open circuit, which means the resistor has failed. Sometimes, a blower motor resistor might fail due to problems with the blower motor itself. This means after replacing the blower motor resistor, check if the blower motor runs freely and doesn’t make any noise.
How to replace blower motor resistor in 2004 Silverado?
This is not a good video on how to replace the resistor for a Silverado Blower Motor. The video is less than 4 minutes and if it takes you that long to replace the resistor sub-assembly it has taken too long. I will try to make better movies in the future. IMPORTANT: Watch my short Video on the Letter I got from GM. Loading…
How much does it cost to replace a blower motor resistor?
The blower motor resistor or control module replacement is not very expensive. For example, one of our colleagues had a problem with his 2011 Ford Escape: the fan only worked at the speed 4. He paid $50 to diagnose and $112 to replace the resistor at a local Ford dealership.
Where is the blower motor resistor on a Mazda 5?
In many cars it’s fairly easy; the blower motor is located behind the glove box and held by 3-4 screws. In others it might be located inside the dash (e;g Mazda 5) which makes replacement difficult. If you need a proper diagnostic procedure, we posted several links where you can access a service manual for your car for a subscription fee.
How does a blower motor resistor control the fan speed?
The blower motor resistor controls the fan speed of the blower motor and the resulting change in air pressure produced by the movement of the blower fan. It accomplishes this by regulating the electric current that powers the motor.
How much does a blower motor resistor cost?
Depending on the manufacturer and model, a blower motor resistor can go anywhere between $3 and $335 on CarParts.com. The replacement parts come in individual units, sets of two resistors, or as part of a blower motor resistor kit.
Why does my blower resistor keep going bad?
Trent, one of the biggest reasons for blower motor resistors to have shorten life is actually because of faulty blower motor drawing too many amps, some times melting wires/plugs, heating up resistors shortening their life. Many Dodge forums tell of this problem.
Can a broken motor switch stop a blower?
A broken blower motor switch can also stop the blower from changing to certain speed settings. If your blower motor cannot change to certain speeds, check both the resistor and the switch on your dashboard. The most common failure points are the resistor and the motor itself.
In our case the ohmmeter shows open circuit, which means the resistor has failed. Sometimes, a blower motor resistor might fail due to problems with the blower motor itself. This means after replacing the blower motor resistor, check if the blower motor runs freely and doesn’t make any noise.
The blower motor resistor or control module replacement is not very expensive. For example, one of our colleagues had a problem with his 2011 Ford Escape: the fan only worked at the speed 4. He paid $50 to diagnose and $112 to replace the resistor at a local Ford dealership.
Where can I buy a Chevy Silverado blower motor resistor?
Buy 2003 Chevrolet Silverado 1500 Blower Motor Resistor from AutoZone. 10% OFF $75. Use Code: DIYSAVE10 Online Ship-to-Home Orders Only
Where does the power transistor go in a blower motor?
The power transistor has 4 wires: two come from the climate control system control unit, one is the ground, one goes to the negative terminal of the blower motor. The service manual advises measuring the voltage at the blower motor, then if not OK, at the power transistor and so on.
The power transistor has 4 wires: two come from the climate control system control unit, one is the ground, one goes to the negative terminal of the blower motor. The service manual advises measuring the voltage at the blower motor, then if not OK, at the power transistor and so on.
Where is the blower motor resistor located on a Ford Escape?
In the 2008-2011 Ford Escape, the resistor is located behind the glove box on top of the HVAC unit air duct. It’s held by two screws and is easy to replace. See the photo. In the 2008-2011 Ford F150 the blower motor resistor is also located behind the glove box, but is installed in the right side of the plastic air duct.
What are the symptoms of a worn out blower motor?
One of the symptoms of a worn out blower motor is that it can intermittently produce a loud screeching noise when running. How to test a blower motor? If the blower motor doesn’t work at all, the blower motor itself must be tested first. Typically it’s done by measuring the voltage at the blower motor connector when it’s turned on.
What are the symptoms of a failed blower motor resistor?
Blower motor resistor problems. Problems with a blower motor resistor are common in many cars. The most common symptom of a failed blower motor resistor is when the heater fan only runs at high speed and doesn’t work at low speeds.
In many cars it’s fairly easy; the blower motor is located behind the glove box and held by 3-4 screws. In others it might be located inside the dash (e;g Mazda 5) which makes replacement difficult. If you need a proper diagnostic procedure, we posted several links where you can access a service manual for your car for a subscription fee.
Is the blower motor resistor on my F 150 still working?
Replaced the blower motor resistor and the fan still will not work – where is the blower mtor in my 2010 F 150 so I can – Answered by a verified Ford Mechanic We use cookies to give you the best possible experience on our website.
What are the symptoms of a bad heater motor resistor?
Symptoms of a Bad or Failing Heater Blower Motor Resistor. 1 1. Blower motor stuck on one speed. A common symptom of a faulty blower motor resistor is a blower motor that is stuck on one setting. The blower 2 2. Blower motor does not work on certain settings. 3 3. No air from the vehicle’s vents.
What is the purpose of a blower motor resistor?
The blower motor resistor is an electrical component that is a part of the vehicle’s heating and air conditioning system. It is responsible for controlling the blower motor’s fan speed. A failed blower motor resistor can cause issues with the operation of the entire heating and air conditioning system.
How much does a blower motor cost?
Based on these factors, the costs, including both parts and labor, can range anywhere from $250 to more than $500 for a standard single speed blower motor. If a blower motor is required for a more expensive unit, such as a variable-speed motor, then the costs could be more than $1,000; however, these motors tend to be relatively rare.
What does a blower motor resistor do?
Definition. A blower motor resistor, typically located beneath the passenger side dashboard, contains three resistors, or sets of terminals designed to generate voltage in proportion to electrical current. These resistors allow the blower motor to function at lower speeds.
What is an AC resistor?
Resistor AC Response. For ordinary currents and frequencies the behavior of a resistor is that of a dissipative element which converts electrical energy into heat. It is independent of the direction of current flow and independent of the frequency. So we say that the AC impedance of a resistor is the same as its DC resistance.