How do you remove a plenum bolt on a Jaguar?
In order to see and remove the passenger side plenum bolt I has to remove the egr. On the driver side, however, I cannot get to the bolt because there is a wire harness routing plastic trunk as well as the driver side intercooler or whatever Jaguar refers to the heat exchangers mounted above both cylinder heads.
How to clear air suspension fault in jagrepair?
1. Park the vehicle on level ground, ensure the ignition is switched ‘OFF’, the steering is in the straight ahead position and the transmission selector lever is in park. 2. Carry out an ignition cycle; engine ‘ON’/key ‘OFF’/ignition ‘ON’/ignition ‘OFF’, to clear the ‘air suspension fault’ message from the message centre. 3.
How to reset the ecu-1 Jaguar car forum?
Restart the clock (where fitted) and set it to the correct time. Simultaneously press “>>” “PTY” “A.MEM” should only take 2 or 3 seconds and the radio turns on. 1. NOTE: After the battery has been disconnected it is necessary to
What are the steps to remove the supercharger?
Here is a illustration. Click on the link. Click on the link. If I remove the 2 rear 10 mm bolts (of which I have already removed 1) and all 4 pan head T40 torx bolts from the back of the plenum to the supercharger, there is still on more 10 mm headed bolt holding the supercharger to the engine correct?
In order to see and remove the passenger side plenum bolt I has to remove the egr. On the driver side, however, I cannot get to the bolt because there is a wire harness routing plastic trunk as well as the driver side intercooler or whatever Jaguar refers to the heat exchangers mounted above both cylinder heads.
Restart the clock (where fitted) and set it to the correct time. Simultaneously press “>>” “PTY” “A.MEM” should only take 2 or 3 seconds and the radio turns on. 1. NOTE: After the battery has been disconnected it is necessary to
What happens to the coolant in a new Jaguar?
On a new vehicle, these pockets of air may take some considerable time to be purged, resulting in a gradual drop in the coolant level. This process may eventually lead to illumination of the coolant warning lamp by the low level sensor located in the coolant reservoir.
Here is a illustration. Click on the link. Click on the link. If I remove the 2 rear 10 mm bolts (of which I have already removed 1) and all 4 pan head T40 torx bolts from the back of the plenum to the supercharger, there is still on more 10 mm headed bolt holding the supercharger to the engine correct?