What are the A and B bolts on a Jaguar?
“A” are the bolts that need to be loosened so that your window can be pushed up and out of the way. When you free the window push it up and I used duck-tape on the outside of the window to hold it up and out of the way. “B” are the nuts that hold your regulator rails in place.
How to install front lower ball joint in Jaguar?
Courtesy of JAGUAR CARS, INC. Tighten nut of special tool 204-114 to full extent, to achieve suspension mid-laden position. Raise front of vehicle and support on stands. Remove appropriate road wheel. Remove and discard tiestraps securing wheel speed sensor harness to upper wishbone. Courtesy of JAGUAR CARS, INC.
How to repair a jagrepair Jaguar F-type?
It did not change the characteristic of the regulator or any of the moving parts. Once installed turn on the key and run the window regulator to the half open position. Hold the window in place from the bottom and remove the tape. Direct the window down until it is set in the two clamps for the window gently and evenly.
How does a Jaguar S-type window regulator work?
Direct the window down until it is set in the two clamps for the window gently and evenly. Turn the key on and close it electrically. In the closed position you will be able to tighten the two bolts “A” that hold and control the window up and down operation.
Can you change the cambelt on a Jaguar 2.7D?
Jaguar S Type 2.7D cambelt change procedure. This is for anyone who wants to change the cambelt on the Stype 2.7D (most likely similar for the XJ too, but I haven’t done one of those so I can’t be certain!).
How to replace timing chain on Jaguar S-type?
Timing chain tensioning tool – Jaguar No.303-532. Crankshaft positioning tool – Jaguar No.303-645/303-531. Primary chain wedges – Jaguar No.303-533. Crankshaft pulley locking tool – Jaguar No.303-191/18G 1437. Crankshaft pulley remover – Jaguar No.303-588.
What kind of bolts do you need to change a cambelt?
The pulley needs to be removed (6 or 8 spline headed bolts), as does the water pump pulley (a locking pin for this is included in the kit, then 3 10mm hex head bolts).