How to reset the parking brake on a jaguar?

How to reset the parking brake on a jaguar?

To reset the parking brake, press and hold the foot brake. While holding the foot brake in position, move the parking brake switch to the ‘Apply’ position. If the electrical supply is disconnected from the parking brake control module, the actuator will loose its position memory.

How to reset jaguar Xf EPB?

Registered

1. Reset the EPB module as detailed below. a.
2. Start the engine.
3. Firmly apply and release the footbrake five times.
4. Confirm that the message ‘NOT CALIBRATED’ or ‘APPLY FOOT.
5. Lightly press the footbrake pedal.
6. Apply the parking brake by using the EPB switch.
7. Release the parking brake.
8. Release the footbrake.

Why is my XJR having a parking break fault?

Here is what it states. On some 2004 MY-on XJ range vehicles, a customer may report a concern of premature parking brake pad wear or the brakes binding. This condition can result if the electronic park brake (EPB) system is not re-calibrated after the removal of the rear brake calipers to replace the brake pads.

What’s the park brake fault on a 2007 XJ?

I am new to this forum but am really frustrated with my 2007 XJ as it has let me down twice this week in the snow. The fault on rhe dash read Park Brake Fault and the brake warning light is lit. then when you sellect park it won’t let you out again and you have to get recovered.

Why does the parking brake not disengage on a 2005 Jaguar?

Re: parking brake will not disengage on 2005 jaguar s… Although a temporary workaround, disconnecting the battery and/or control module to release the park does not resolve why it became locked-on in the first place. The problem with many many S-types has been a failure of the park brake motor.

Is it OK to disconnect Jaguar XJ8 battery?

Don’t disconnect your XJ8 battery if you can help it. – Page 1 – Jaguar – PistonHeads UK Don’t disconnect your XJ8 battery if you can help it. It can cause various relays to “stick” open and subsequently drain the battery.

Here is what it states. On some 2004 MY-on XJ range vehicles, a customer may report a concern of premature parking brake pad wear or the brakes binding. This condition can result if the electronic park brake (EPB) system is not re-calibrated after the removal of the rear brake calipers to replace the brake pads.

How do you reset the parking brake on a Jaguar?

Pump the brakes then press and hold the brake pedal while you pull up on the parking brake switch as this will usually reset the brake. Ask Your Own Jaguar Question Was this answer helpful?

How to apply parking brake on 2006 XJR?

Confirm that the message “NOT CALIBRATED” or “APPLY FOOT AND PARK BRAKE” is displayed on the instrument cluster message center. This indicates that the parking brake is in calibration mode. 5. Lightly press the footbrake pedal. 6. Apply the parking brake by using the EPB switch. 7. Release the parking brake. 8. Release the footbrake. 9.

Don’t disconnect your XJ8 battery if you can help it. – Page 1 – Jaguar – PistonHeads UK Don’t disconnect your XJ8 battery if you can help it. It can cause various relays to “stick” open and subsequently drain the battery.