Where is the OBD2 port on Jaguar XK?

Where is the OBD2 port on Jaguar XK?

Where is the OBD2 port on Jaguar XK (1996 – 2015) ? Mode X column: A vehicle showing 00000000 on a mode means that no corresponding PID is active and that as a result the mode is supported but will not reply to any requests. None of the vehicles described below support mode 8.

When does the Check Engine light come on on a Jaguar XJ8?

Intermittent Check Engine Light: If the check engine light on your 2008 XJ8 is intermittent, try to take note of the conditions when this happens. For example, does it happen when you accelerating, driving on the highway or does it appear at low speeds?

Where to find check engine light codes on a Jaguar?

These are listed in numerical order for easy searching. When retrieving Jaguar check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.

What to do with a 2008 Jaguar XJ8?

2008 Jaguar XJ8 L 4.2L V8 Change a flat tire Learn where your spare tire and jack are located before you need it on the side of the road 2008 Jaguar XJ8 L 4.2L V8 Determine if your air filter is dirty Learn where your air filter is located and how to determine if it needs to be changed.

Where is the OBD2 port on a Jaguar XJ8?

OBD2 port Jaguar XJ8 – Find your plug ! Where is my OBD2 port ? All vehicles are equipped with an OBD port to which you can connect your klavkarr diagnostic case. Sometimes, the most difficult thing is to find this port!

What are the trouble codes for a Jaguar?

So to be 100% accurate you’ll need to refer to a service repair manual specific to your year/model/engine configuration such as Jaguar Technical Information System (JTIS) or possibly AllDataDIY. Other Jaguar-specific content on our site: Trouble codes that start with P0, P2, P34, B0, C0, U0, or U3 are all considered “generic”.

What is the Mil code on a Jaguar X350?

Jaguar X350 ECU1 ($FD20) ECU1 (FD00) Codes? Hi all and good afternoon from a cold and windy Northumberland. The MIL has suddenly started appearing on my 2005 X350. I plugged the iCarsoft in and on the Jaguar specific search it came back with “Fault in communication with vehicle ECU”.

What should intake manifold pressure be on a Jaguar?

Intake manifold pressure is a steady 9.2 inHg and from what I gather it should be 15-20. Both upstream O2 sensors are both at .000 volts but they should be fluctuating between .1v and .9v. Both The car runs great but will not pass smog test…. The catalytic converter will not reset to be ready for a smog test.