What should I do if my Jaguar door module fails?
On older XJ’s the first port of call was to check all the connections on the various modules, I’m not sure if the X350 suffers in the same way but I’ll have a check & a look at the DDM to see if there are any signs of water ingress etc. Many thanks John
Is the security module on a Jaguar working?
Am i correct in assuming that the security module is working because the alarm works, key fob programming sequence works.
How do you remove the passenger door module?
This method of removal applies to both the driver door module (DDM) and the passenger door module (PDM). The illustration shows the driver door module (DDM). Ignition off Remove the door panel Remove the nut and screw holding the door module Disconnect the connectors Pry up the rear edge of the door module.
Is there a problem with the DDM in a Jaguar?
Had door card off to look at DDM but nothing obvious such as signs of water or damp on the unit is visible. The only thing I noticed was electrical tape around the wiring as it enters the rubber cover before it leaves the door.
Where are the control modules located on a Jaguar?
“GEM” (General Electronics Module) is mentioned for “earlier” models only in the 2002-2008 Workshop Manual. “PCM” (Powertrain Control Module) is only present in 2002+ models . “TCM” (Transmission Control Module) is only present and within the transmission in 2002+ models (ZF Gearbox).
On older XJ’s the first port of call was to check all the connections on the various modules, I’m not sure if the X350 suffers in the same way but I’ll have a check & a look at the DDM to see if there are any signs of water ingress etc. Many thanks John
Had door card off to look at DDM but nothing obvious such as signs of water or damp on the unit is visible. The only thing I noticed was electrical tape around the wiring as it enters the rubber cover before it leaves the door.
What do you need to know about Jaguar electrical systems?
ADVANCED JAGUAR ELECTRICAL SYSTEMS JAGUAR SERVICE TRAININGJAGUAR SERVICE TRAINING 1 GENERAL INFORMATION 2 JAGUAR ELECTRICAL SYSTEMS 3 XJ / XK 4 S-TYPE 5 X-TYPE 6 TASK SHEETS
Can You program the FOBS on a Jaguar?
I tried programming the fobs & the sequence worked after the 5th flash & after completion by removing the key.I didn’t get any response when I pressed the key fob buttons during the programming stage, even after many attempts.
How do you remove the inside door panel on a Jaguar?
The first process is to remove the inside door panel. To do this remove the two screws located in the armrest (look down from the top). The panel is only held in place by these two screws and seven push pins mounted on the panel. You will need to remove the panel by carefully pulling it away from the door.
Where to replace the regulator on a Jaguar?
My first regulator replacement was on the left rear door, the second was on the right front door and this one the left front drivers door and soon I am sure will be the right rear door. The first regulator took me about 30 min.
How does a Jaguar S-type window regulator work?
Direct the window down until it is set in the two clamps for the window gently and evenly. Turn the key on and close it electrically. In the closed position you will be able to tighten the two bolts “A” that hold and control the window up and down operation.