What is the correct gear ratio code p0735?
Incorrect ratio codes typically require an advanced mechanical ability and diagnostic tools. Note: This code is similar to P0730, P0730, P0731, P0732, P0733, P0734 and P0736. If there are other transmission codes, repair those problems first before proceeding with an incorrect gear ratio code.
When to use Ford OBD code p0735?
– Low transmission fluid level – Dirty transmission fluid – Shift solenoids – Transmission mechanical problems – Transmission hydraulic control circuit The Error code is generally activated on detection of the following conditions: P0735 is detected when A/T cannot be shifted to the 5th gear position even if electrical circuit is good.
What are the symptoms of an incorrect gear ratio code?
If there are other transmission codes, repair those problems first before proceeding with an incorrect gear ratio code. Symptoms of a P0735 trouble code may include: Check Engine Light illuminated (Malfunction indicator lamp) Causes of this DTC may include: Internal blockage inside transmission main control
What causes a car to not shift into 5th gear?
Blocked fluid passage inside the transmission can also cause the vehicle to not shift into 5th gear, if there are multiple incorrect ratio codes but the transmission performs as expected, there could be a mechanical issue with the torque converter, transmission main control, or pressure problems.
Where is the p0735 gear 5 trouble code?
The P0735 code is an indicator that the automatic transmission can’t be shifted to the 5th gear. This code is used in vehicles that are built with automatic transmissions/transaxles that rely on torque converters to drive the rear wheels and increase the engine torque output. The converter is located between the transmission and the engine.
What is the diagnostic code for gear 5 incorrect ratio?
P0735 is a diagnostic trouble code (DTC) for “Gear 5 Incorrect Ratio”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
What does po735 stand for in Allison Transmission Code?
PO735 is 5th gear incorrect ratio, meaning 5th gear is slipping. I know about the 5th gear ratio but can a NSBU cause this code or cause my drive or reverse to go to neutral if i don’t put foot on throttle right away
– Low transmission fluid level – Dirty transmission fluid – Shift solenoids – Transmission mechanical problems – Transmission hydraulic control circuit The Error code is generally activated on detection of the following conditions: P0735 is detected when A/T cannot be shifted to the 5th gear position even if electrical circuit is good.