How do you reset the trouble light on a DSC alarm?
DSC Security System Trouble Light When a trouble is present the system trouble indicator light will illuminate and the keypad will beep every 10 seconds. To silence the trouble beep simply press the # key on the keypad. Now press *2 on your security keypad.
How do I turn off my DSC alarm light?
How can I silence the trouble beep on the keypad? Press the ‘#’ key to silence the beeping, however you will need to fix the problem before the light will go out. You can also press ‘9’ after ‘*2’ to acknowledge and cancel the trouble condition but you still must fix the problem.
How do I factory reset my DSC 1832?
Time to factory reset the system. To do this you have to short the zone 1 pin (not the z1 common pin) with the PGM1 pin. Thus, you have to ground Z1 to PGM and power the system up for 10 seconds and then power it off, remove the jumper and then power it back on.
What causes the DSC fault system warning light?
Q: DSC Fault System warning light. DSC Fault System is showing on the dashboard. The DSC (Dynamic Stability Control) system on your vehicle uses a number of inputs to be able to perform its duties. The most common cause of the DSC fault light showing up is a low vehicle battery or a bad connection at the battery.
When does the DSC light come on and off?
Finally, your DSC light will come on when the system is in use. Unlike when there’s a problem in the system, the light will flash on and off repeatedly when this is happening. Additionally, you’ll feel your vehicle applying the brakes to specific wheels to help you maintain control of your vehicle.
Is it safe to drive with a DSc light?
Because if there is a possibility that the DSC system could kick on when it shouldn’t while you’re driving. While it’s rare, it can happen. But if you’ve manually turned off the DSC system or you know that’s it’s completely disabled, it’s safe to drive with a DSC light.
Can you turn off the DSC light on a BMW?
Whether you know it or not, you can turn your DSC system off. All you need to do to turn the system off in a BMW is hold the DSC light for at least three seconds. This will disable the DSC system, which can be helpful if you’re trying to drift.
Why does my DSC light keep coming on?
Unless the DSC light is coming on when it shouldn’t, this isn’t a problem and you’re good to go. The most common causes of a BMW DSC light are that you’ve accidentally turned the system off or you have a faulty wheel speed sensor.
When do I get the DSC system fault warning?
I’ve started getting the “DSC System Fault” message and warning light intermittently. Sometimes it appears while I’m driving, sometimes on startup. If I turn everything off and restart the car it sometimes clears.
Because if there is a possibility that the DSC system could kick on when it shouldn’t while you’re driving. While it’s rare, it can happen. But if you’ve manually turned off the DSC system or you know that’s it’s completely disabled, it’s safe to drive with a DSC light.
How can I get my DSC Alarm back to normal?
These simple steps will have your alarm system back to normal in less than 5 minutes! Open the access door and enter your master code twice. Pull down the panel that covers the keypad on your alarm system. After this, simply enter your 4 digit master code, wait 2 seconds, and then enter it again.