Where is the radiator drain on a Jaguar XJ?
RADIATOR DRAIN: Up until somewhere around 1988, the XJ-S was fitted with one of the most obnoxiously overdesigned radiator drain cocks in automotive history: a metal drain valve at the bottom right corner of the radiator, operated by a lever that extended up to just below the upper hose fitting.
How to drain coolant from the Jaguar cooling system?
Fill the cooling system up to the MAX mark on the coolant expansion tank using a fifty percent mixture of Jaguar Premium Cooling System Fluid or equivalent, meeting Jaguar specification WSS M97B44-D and fifty percent water. Install the coolant expansion tank bleed screw.Tighten to 3 Nm.Do not over tighten the coolant expansion tank bleed screw.
How often should I change the radiator in my Jaguar XJS?
Inspect also the lower section of the radiator. At least every two years, drain the system, flush and re-fill with fresh anti-freeze solution.Capacity, with heater (approximately): 37 pints (21 litres). At each service, check all drive belts and renew if worn/damaged (replace in any event every 60,000 miles).
Is there a leak in the XJ-S cooling system?
In theory, leak sealers will not solidify until they come in contact with air; however, there is always a little air INSIDE a cooling system, and in the case of the XJ-S there is apparently enough to cause trouble. Please, do not use any leak-sealing substance within the V-12 cooling system.
RADIATOR DRAIN: Up until somewhere around 1988, the XJ-S was fitted with one of the most obnoxiously overdesigned radiator drain cocks in automotive history: a metal drain valve at the bottom right corner of the radiator, operated by a lever that extended up to just below the upper hose fitting.
Can a Jaguar XJ-S have a cooling system?
In theory, leak sealers will not solidify until they come in contact with air; however, there is always a little air inside a cooling system, and in the case of the XJ-S there is apparently enough to cause trouble. Please, do not use any leak-sealing substance within the V12 cooling system.
Why is coolant coming out of the bottom of my Jaguar?
For all this effort and expense, Jaguar couldn’t bring themselves to provide an outlet out the bottom of the car, so opening the drain valve causes coolant to pour all over the structures in the area and dribble out wherever the catch pan isn’t.
Do you have to flush the radiator on a Jaguar?
Even if you have the earlier system with the drain cock, there may be wisdom in disconnecting the hose to drain anyway — or at least to flush. Plugged up radiators are a staple of Jaguar ownership, and perhaps opening the big hole in the bottom will flush out more junk than using the tiny drain.
When did the cooling system change on a Jaguar?
Somewhere around 1988 — possibly coinciding with the introduction of long-life phosphate-free coolant — Jaguar went from the overdesigned drain cock to no drain cock at all. On later cars, it is necessary to disconnect the lower radiator hose to drain the coolant. Wearing a tux is not recommended.
What happens when you disconnect the battery on a Jaguar?
When the battery is disconnected, these adaptations are lost. On reconnection, therefore, some slightly abnormal drive symptoms may occur and the vehicle may need to be driven10 miles (16 kilometres) or more while the control system re-adapts. this is a simple link for resets after battery disconnect.
How to reset the ecu-1 Jaguar car forum?
Restart the clock (where fitted) and set it to the correct time. Simultaneously press “>>” “PTY” “A.MEM” should only take 2 or 3 seconds and the radio turns on. 1. NOTE: After the battery has been disconnected it is necessary to
How to drain the jagrepair Jaguar cooling system?
Disconnect the auxillary coolant flow pump electrical connector. Remove the dual coolant flow valve: 1.) Remove the retaining bolt. 2.) Remove the dual coolant flow valve. Remove the dual coolant flow valve hoses. To install, reverse the removal procedure.Tighten to 10 Nm.
Where is the bleed valve on a Jaguar?
Rev the RPM’s up a few times, check coolant tank and keep filling up as necessary. Repeat this until coolant tank is a hot mark, close coolant tank bleed screw and cap and you’re all set. Now, the bleed valve. It’s on a pipe just to the lower right of the throttle body at the front of the engine (it is marked).
When to change the oil on a Jaguar?
Oil & Filter Change Jaguar X-Type (2002-2008) If your X-Type is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your X-Type. Most Jaguars have the oil type printed on the oil cap – it will likely be 5W-20, 5W-30, 5W-40, 10W-30 or 10W-40.
What kind of coolant does a Jaguar use?
Fill the cooling system up to the MAX mark on the coolant expansion tank using a fifty percent mixture of Jaguar Premium Cooling System Fluid or equivalent, meeting Jaguar specification WSS M97B44-D and fifty percent water. Do not over tighten the coolant expansion tank bleed screw.
What to do if your Jaguar radiator overheats?
Crud in the system will cause overheating under all conditions, but usually more at speed than at idle. Since Jaguar manuals recommend the use of Barrs Leaks, any radiator that has been maintained according to the manual is likely to be plugged. 2. Suspend the thermostats in a pan of water on the stove and bring them to a boil.
Somewhere around 1988 — possibly coinciding with the introduction of long-life phosphate-free coolant — Jaguar went from the overdesigned drain cock to no drain cock at all. On later cars, it is necessary to disconnect the lower radiator hose to drain the coolant. Wearing a tux is not recommended.
Why are the valve seats on a Jaguar?
Since the heads are aluminum, the valve seats are steel rings that are pressed into the aluminum. Since steel and aluminum have different coefficients of thermal expansion, overheating will cause a loose fit and the seat can just fall out.