How do I replace my Jaguar key?

How do I replace my Jaguar key?

If a Smart key is lost, a replacement can be obtained and reprogrammed to the vehicle by a Retailer/Authorised Repairer. Notify a Retailer/Authorised Repairer as soon as a Smart key is lost or stolen and have the remaining Smart key(s) reprogrammed.

What’s the problem with my Jaguar XF battery?

My 2010 Jaguar XF has a battery drain issue. I’ve monitored My 2010 Jaguar XF has a battery drain issue. I’ve monitored the readings and within 10 min of engine off it can lose 0.4v, and go on to lose 0.6v per night.

What should I do if my Jaguar alarm keeps going off?

With everything locked and the alarm armed, try gently lifting the bonnet to see if you can trigger the alarm. The switch may just need re-positioning. no cat paw prints on the bonnet? As you can push the bonnet down slightly I would adjust to the two stops, one each side, to hold the bonnet firmly.

What should the current drain be on a Jaguar XF?

A typical current drain with everything off and un-alarmed should be around 0.05Amp and if its higher than this remove a fuse and re-measure, if measurement doesn’t change then replace the fuse and remove the next.

What to do if your car alarm keeps going off?

Alarm keeps going off. Hi all. As title says it has gone off 4 or 5 times now have looked on the web and i found i could find out what the problem was by looking at the display and it comes up volumetric sensor what is this and how can i stop alarm going off. Can i just turn the tilt sensor off will this stop it going off.

Where is the alarm on a Jaguar X-type?

With a bit of research and managing to download the official Jaguar X-Type electrical guide the solution was quite straight forward. The main unit that controls the alarm is the Generic Electronic Module (GEM) which is located in the driver footwell, the electical guide gives the circuit diagrams and the pin outs from the GEM.

My 2010 Jaguar XF has a battery drain issue. I’ve monitored My 2010 Jaguar XF has a battery drain issue. I’ve monitored the readings and within 10 min of engine off it can lose 0.4v, and go on to lose 0.6v per night.

A typical current drain with everything off and un-alarmed should be around 0.05Amp and if its higher than this remove a fuse and re-measure, if measurement doesn’t change then replace the fuse and remove the next.

Why does my car alarm keep going off?

It never reports the last sensor to trigger the alarm and when the alram goes off, it is just the sounder, no lamps flashing or such. I can also push the bonnet down slightly and there is a bit of movement.