What should I do if my Jaguar handbrake is not calibrated?
Disconnect the battery for 30 seconds. Reconnect the battery. 2. Start the engine. 3. Firmly apply and release the foot brake five times. 4. Confirm that the message “NOT CALIBRATED” or “APPLY FOOT AND PARK BRAKE ” is displayed on the instrument cluster message centre. This indicates that the parking brake is in calibration mode. 5.
Where is the parking brake warning light on my Jaguar?
The dreaded Parking brake warning light came up on the dash a couple of days ago. I have tried re-set procedure (disconnect battery etc.) to no avail. I am reasonably handy with a multimeter and was wondering if anyone has a procedure for testing the centre console operating switch, to try and eliminate one part of the system.
Can a parking brake be removed from a Jaguar?
Drove until first stop and then park brake locked on and Selector stuck in P. Jaguar Assist called and passed to AA. Selector sorted by lifting and moving lock located to left of gear stick. Brake still locked on. Battery removal no go. Removed the two plugs from Park Brake module (right hand side boot level with fuel filler.
What causes hand brake problems in a Jaguar?
Also worth checking, and this can cause Hand Brake problems, is the state of the inside faces of the rear Discs, as these can wear/score quite badly, with this wear being concealed by the brake back plate assembly. Telfer.
Disconnect the battery for 30 seconds. Reconnect the battery. 2. Start the engine. 3. Firmly apply and release the foot brake five times. 4. Confirm that the message “NOT CALIBRATED” or “APPLY FOOT AND PARK BRAKE ” is displayed on the instrument cluster message centre. This indicates that the parking brake is in calibration mode. 5.
How to reset the parkbrake on a 2005 Jaguar’s Type?
3 people found this helpful. Mine is a 2005 S Type sports automatic. I’ve had the warning message, and the parkbrake stuck on, five times, due to a low battery in cold weather. The first time, a Jaguar agent reset it by fiddling about in the boot for less than a minute.
How are the warning lights displayed on a Jaguar?
If a warning message is displayed along with a red warning light (highest priority), investigate the fault immediately. If more than one message is active, each is displayed in turn for two seconds in order of priority. Displayed when the brake fluid level is low. Depending on your location, warning light may be displayed in red letters BRAKE.
What to do when the parkbrake doesn’t work?
Turn off the lights etc. Run the engine for five minutes to charge the battery a little. Switch off the ignition until every warning light goes out. Turn on the ignition again. The parkbrake then works normally, and the warning has gone. 9 people found this helpful. Worked for me.