How do I calibrate my park brake?
Re: Park Brake Requires Calibration If the battery has been discharged or disconnected, Apply Foot And Park Brake will be displayed in the Message center when the ignition is next switched on. Press the brake pedal and pull the EPB switch up to apply the EPB. This is required to reset the EPB system.
How to calibrate a jagrepair EPB motor?
To do this, set the system into ‘Calibration Mode’ by doing a battery reset. Then, with ignition ‘ON’ and the vehicle brakes at room temperature, lightly press the brake pedal and apply the parking brake. Date of issue 12/05 Bulletin Number XJ206-07 Page 3 of 10 DTC C1784 – EPB MOTOR OUTPUT SHORT TO GROUND.
How do I re-calibrate my EPB after a fault?
After repairing any EPB actuator fault, the EPB must be re-calibrated. To do this, set the system into ‘Calibration Mode’ by doing a battery reset. Then, with ignition ‘ON’ and the vehicle brakes at room temperature, lightly press the brake pedal and apply the parking brake. Date of issue 12/05 Bulletin Number XJ206-07 Page 3 of 10
When to use the electric parking brake ( EPB )?
Do not rely on the Electric Parking Brake (EPB) to hold the vehicle stationary if the brake warning lamp is illuminated or the EPB warning lamp is flashing. Seek qualified assistance immediately. The EPB operates on the rear wheels; therefore, secure parking of the vehicle is dependent on being on a hard and stable surface.
What to do when the parking brake is released?
Warning:Ensure the vehicle cannot roll away when the parking brake is released. Chock the road wheels, and on automatic vehicles ensure the gear selector is in park. 4. Apply and release the parking brake five times using the apply/release switch. 5. Recheck the failure memory for DTCs. DTCs that return are permanent faults.
Do you need to do a parking brake calibration?
NOTE: After carrying out any work on the parking brake or rear brake calipers and discs, the parking brake requires calibration. ^Switch the ignition off.
Do not rely on the Electric Parking Brake (EPB) to hold the vehicle stationary if the brake warning lamp is illuminated or the EPB warning lamp is flashing. Seek qualified assistance immediately. The EPB operates on the rear wheels; therefore, secure parking of the vehicle is dependent on being on a hard and stable surface.
When does the parking brake warning light flash?
The parking brake warning light flashes when a fault has arisen. If you are unable to release the parking brake, use the button to apply and release the parking brake. Several attempts may be required. If the battery voltage is low, it may not be possible to release the parking brake. Connect a donor battery if the battery voltage is too low.
What to do if you cant release the parking brake?
If you are unable to release the parking brake, use the button to apply and release the parking brake. Several attempts may be required. If the battery voltage is low, it may not be possible to release the parking brake.