What does the red triangle on the remote control mean?
If the red warning triangle symbol (LED 3) on the remote control illuminates, this indicates a system error. In this case apply the parking brake, switch the remote control off and then on again after two seconds. Reset with the parking brake applied.
What does red flashing on remote control mean?
Red flashing on the control unit If the driving functions of your Mover are restricted (you cannot drive around corners, for example) there may be a defect in the control unit. Therefore, don’t only pay attention to the error messages indicated by flashing on the remote control, but also take a look at the control unit.
Why is there no signal on my Remote Control?
If, after switching on the remote control you hear an acoustic signal (four times) and the red warning triangle (LED 3) is also flashing, there is no connection between the remote control and the control unit. This could be due to several reasons: No battery voltage: check the voltage of your 12 V battery.
Where is the reset button on a DSc alarm?
This button is usually located on the bottom right side of the keypad. Hold it down for at least 2 seconds to disengage the alarm. You will notice the lights on the alarm change from red to green to signal that the alarm has been reset. This also helps to reset the low battery light once the power has been restored.
How can I Stop my DSC alarm from beeping?
The first step is to stop the beeping so you can calmly trace and work on the trouble that caused the system to beep. Using any keypad, check if the alarm system is disarmed. If it is not, put in your disarm code. Press the pound (#) key. To know the trouble detected by your alarm system, press the star (*) key, followed by number 2.
Can a burglary alarm be set off by a motion detector?
If someone enters an area covered by a motion detector while the system is armed, the burglary alarm will sound. Motion detectors are sensitive to the slightest movement and can easily cause a false alarm.
What happens when a burglary alarm is tripped by ADT?
When the system is tripped, the burglary siren will sound and a signal is sent from your alarm system to ADT’s Customer Monitoring Centers, where it appears on a monitoring representative’s computer. 8. How can I avoid setting false alarms? Sometimes people avoid using their security system because they’re afraid of setting it off accidentally.
Why do I get a red triangle when I send a text?
I have gotten this error when the network (not VZW) was down, like during the East Coast Earthquake in August. The phone would try to send the text message multiple times (I think), then gives up and I got the error. The differences are my messages never went through and it happened for all numbers, not just one.